View Larger Picture

Additional Pictures:	Picture 1 Picture 2 Picture 3
On-line Videos:	Video 1 (1.5 MB)
Product Reviews:	Review 2
Instruction Manuals:	Manual 1 (267 KB)
Tower Catalog Page:	144
E-mail This Page To A Friend

  This is the Nitro Hammer RTR Radio Controlled Nitro Powered Deep Vee Boat
                                by AquaCraft.

FEATURES: Virtually everything is installed or assembled.
          Includes a boat stand and a video that shows how to break in and
            maintain the included .15 Marine engine with recoil.
          Fuelproof fiberglass hull and deck are prejoined, and factory-
            finished.
          Each color corresponds to a different radio frequency, and all
            are protected by a tough Gel Coating.
          AquaCraft engine is a true ABC engine, with dual bearings, and a
            two needle carburetor. Glow plug, manifold, tuned pipe, and
            engine break-in video included.
          The receiver and servos for the AquaCraft 2-channel radio are pre-
            installed. The radio is made by Futaba, the #1 name in R/C radios.
          The radio has adjustable steering rates, trims, servo reversing,
            a battery monitor, charge jack and a light and well balanced feel.

INCLUDES: Ready to Run Nitro Hammer GP Deep Vee boat, with radio, boat stand,
            2-channel AM Pistol Style 75MHz radio, .15 Marine Engine w/recoil
            with header and tuned pipe, and engine break-in video.

REQUIRES: 20% Glow Fuel
          Glow Starter
          12 "AA" batteries for the radio.

SPECS:    Length:    24" (610mm)
          Beam:      8.75" (220mm)

COMMENTS: The hull color of each boat is different depending on radio channel;
             AQUB2662White          AQUB2670 Yellow
            AQUB2664 Blue           AQUB2672 Gray
            AQUB2668 Red            AQUB2674 Orange

          From the Research & Development Department.

          What to use for hull repairs.
          The Nitro Hammer boat has a gel coat on the outside of the
          hull. WE DO NOT RECOMMEND THE USE OF AUTOMOTIVE FIBERGLASS RESIN
          TO DO ANY REPAIRS TO THE HULL. IT IS TOO STRONG TO USE AND COULD
          RESULT IN A DAMAGED HULL. It was suggested to use Epoxy (GPMR6043)
          mixed with micro balloons (TOPR1090). Mix together, apply to damaged
          part of the hull, smooth out, let cure and wet sand if needed for a
          good smooth solid repair.

                                                                    kh 08/07/02
                                                              updated- 08/25/03
                                                          updated/JCT/ 04/20/04
                                                            Updated JBM 1-17-06



– If you need more information, use these AquaCraft resources –

Click Here: Manufacturer's Product Web Page
E-mail: boatsupport@hobbico.com
Web Site: http://www.aquacraftmodels.com/
Phone: 217-398-8970


 
Postal Address:
AquaCraft
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators