Tower Catalog Page:	107
E-mail This Page To A Friend

            This is the electric powered Ready To Run 1/10 scale
                 Tamiya Nismo Coppermix Silvia On-Road Car.
         This vehicle is part of Tamiya's XB (Expert Built) series.

FEATURES: Chassis: Plastic bathtub TT-01 design
          Drive: Four wheel shaft drive
          Radio: Tamiya Expec TTU-03 AM pistol-grip w/servo reverse, steering
            and throttle trims and standard servo
          Electronic Speed Control: TEU-101BK with reverse, TAMM3194
          Motor: 540 motor with pre-attached leads
          Lights: LED head and tail lights
          Ball Bearings: Installed in differentials, bushings in wheel hubs
          Shocks: Friction, plastic body
          Gearbox: Sealed, front and rear
          Differentials: Bevel gear, ball bearing equipped
          Transmission: Single speed
          Body: .03" (.8mm) polycarbonate, painted and trimmed
          Tires: Black rubber
          Wheels: Black 5-Spoke 2.04" (52mm) outer diameter
          Bumper: Grey foam
          Suspension: Fixed, non-adjustable
          Camber Tie Rods: Fixed, non-adjustable,
          Steering Tie Rods: Fixed, non-adjustable
          Steering: Bell-crank type with servo saver

INCLUDES: Tamiya Nismo Copper Silvia on-road car, pistol-grip transmitter,
            receiver, 540 motor, ESC, painted body, tires, foam bumper, spoke
            wheels, decals and instructions

REQUIRES: Radio Batteries: 8 AA size (for transmitter)
          Battery:         6 flat pack with standard connector
          Charger:         AC/DC Timed or Peak for 6-cell battery
          Misc. Items:     Building and track equipment

SPECS:      VEHICLE-
          Length: 15.25" (387.35mm)
          Width: 7.25" (184.15mm)
          Height:   5"    (127mm)
          Weight: 41oz (1165g)
          Tires, F&R:   Overall Diameter: 2.5" (63.5mm)
                        Overall Width:      1" (25.4mm)
             BODY-
          Length:  17.5" (444.5mm)
          Width:    7.5" (190.5mm)
          Height:   4.5" (114.3mm)

COMMENTS: For Replacement Ball Bearings use:
            Qty.  Size      Location                       Bearing Set Qty.
            12   5 x11mm   front & rear diff gears, hubs  (use 6 DTXC1547)
             4   8 X12mm   front & rear diff gears        (use 2 DTXC1597)

          Body shown on box is painted silver with all body trim and decals
            applied

                                                                    jxs 8/28/06
                                                                         ir/jxs



– If you need more information, use these Tamiya resources –

E-mail: us_support@tamiya.com
Web Site: http://www.tamiya.com/
Phone: 800-826-4922


 
Postal Address:
Tamiya
36 DISCOVERY WAY SUITE 200
IRVINE, CA 92618  








Click here for Units of Measure Conversion Calculators