This is an Adapter Kit Used To Mount Tru Turn Aluminum Spinners Onto The:
Saito 1.20 (old) single, 150 (old) single, 170 Radial,
1.80 (old) single and 3.25 four stroke engines.
(For Pre-1999 Saitos See COMMENTS)
FEATURES: Steel Adapter Nuts Screws Onto The Crankshaft Holding the Propeller
On, Then A 10-32 Bolt Screws Into The Nut From Front, Holding The
Spinner In Place.
INCLUDES: One Short Shaft Double Jam Nut Adapter Kit
REQUIRES: 1/2" End Wrench To Tighten
Tru Turn Aluminum Spinner
SPECS: Crankshaft Thread Size: 8 x 1.25mm
Spinner Mounting Bolt Thread Size: 10-32
COMMENTS: While This Adapter Does Not Use A Bushing, It Is REQUIRED That Some
Modifications Be Made To The Spinner Backplate. The Backplate
Must Be Reamed Out To 10mm (.394) For 1.20 or Larger (Except 1.30)
Engines. This Must Done Accurately!
Use The Saito Aluminum Washer Under Your Tru Turn Adapter Nut
and Washer, Then Check Closely For Threads Bottoming Out Or
Interfering.
Tru Turn Will Modify Backplate For A Small Fee and Postage Paid.
The 10-32 Bolt That Is Included With The Spinner Might Require
Cutting, Depending On The Prop Used.
Older Saito Engines (Pre-99) Will Use The TT-0828-A. This
MAY BE REPLACED BY The TT-0822-A and CAN NOT Be Used In ANY NEW
Applications.
JAL 6/11/99
ir/jl
updt jxs 12/22/04
– If you need more information, use these Tru Turn resources – |
E-mail: supertech@truturn.com
Web Site: http://www.tru-turn.com/
Phone: 281-479-9600
|
|
Postal Address:
Tru Turn
ROMCO MANUFACTURING, INCORPORATED
PO BOX 1896
DEER PARK, TX 77536
|
Click here for Units of Measure Conversion Calculators
| 
Yes
E-mail This Page To A Friend
