View Larger Picture

E-mail This Page To A Friend

  This is a Futaba 3FR Skysport SS3 (Single Stick) FM 3 Channel Radio System
                  with two S3114 Micro High Torque Servos.
         Does not include servo accessory packages or receiver battery.

    Designed for Electric, 1/2A Airplanes, Gliders or Hand Launch Gliders.
                   Available in 72MHz (channels 11-60)

This Futaba radio is diode protected to prevent overcharging, which means that
          the battery cannot be discharged through the transmitter.

FEATURES: Single stick design on the right side of the transmitter
          Designed for aileron, elevator or rudder and throttle control
          Proportional third channel slide switch on the front left side of
            transmitter
          V-Tail mixing/elevon
          An ergonomically designed transmitter case contoured to fit the
            pilot's hand, with a left-thumb recessed area, and an "S" curve
            shape for positioning the right hand naturally while operating the
            stick. The side-to-side stick movement follows the natural geometry
            of thumb motion at approximately a 10° angle.
          Servo reversing switches for 2 channels (aileron and elevator) are
            on the lower front face of the transmitter. The 3rd switch is for
            turning the "V-tail Mix" feature ON and OFF.
          Mechanical trims
          R114F BEC receiver is included
          2-LED battery level (Green-full, flashing Red-low voltage)
          Charging jack is pre-installed for included Tx NiCd battery
          Narrow band, excellent for adjacent channel rejection
          One year warranty

INCLUDES: One Transmitter with Tx crystal installed
          One Transmitter Antenna                   (FUTM5111)
          One R114F FM Narrow Band BEC Receiver    (FUTL0442 Lo or FUTL0443 Hi)
          One Receiver Crystal                     (FUTL62** Low or High)
          One Transmitter NiCd battery             (FUTM1440)
          Two S3114 Micro High Torque Servos       (FUTM0414)
          One Switch Harness w/BEC Connector       (FUTM4505)
          One Frequency Identification Flag Set      No Number
          One Instruction Manual                     No Number

SPECS:    Transmitter: Current Drain: 180mA
          Receiver: Current Drain:    18mA
          Servo       6V                    4.8V
           Torque: 23.6 oz/in            21 oz/in
           Speed:  .09 sec/60°         .10 sec/60°
           Dimensions: .86 x .43 x .78" (21.8 x 11 x 19.8mm)
           Weight: .275oz (7.8g)

COMMENTS: This radio is Diode Protected so the transmitter battery cannot be
             Discharged or Cycled while in the transmitter. Battery Dischargers
             and voltmeters Will Not work with this transmitter. To Cycle the
             transmitter battery, take it out of transmitter and cycle it
             directly.

          Order FUTL96** if crystal set is needed.

                                                                   jxs 11/20/06
                                                                         ir/jxs



– If you need more information, use these Futaba resources –

Click Here: Manufacturer's Product Web Page
E-mail: support@futaba-rc.com
Web Site: http://www.futaba-rc.com/
Phone: 217-398-8970


 
Postal Address:
Futaba
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators