Parts Express Eligible:	Yes
Tower Catalog Page:	181
E-mail This Page To A Friend

      This is a TOWER HOBBIES Lo Profile Servo with a Universal Connector.

FEATURES: Low, flat, profile design fits into narrow airfoil wings easier
          Strong, dependable gear train
          High torque
          Contains one ball bearing and one oilite bushing
          Mounts with two screws
          Universal Connector Fits Futaba, Hitec, JR, KO Propo, Airtronics Z,
            and Tower Hobbies.
          One Year Warranty
          Travels 180° - full-lock to full-lock -- to hold your gear in
            position securely. Not proportional. Perfect for mechanical retract
            installation. (see COMMENTS)

INCLUDES: One TS-63R lo-profile retract servo
          One 7/8"x7/8" X-shaped servo horn
          One 1 1/8" long straight servo horn
          One 11/16" diameter round servo horn
          Two brass eylets
          Two mounting screws
          Two servo grommets
          One servo horn screw

SPECS:    Length: 1.7" (43mm)
          Width:   .9" (23mm)
          Height to top of case: 1" (25.4mm)
          Transit Speed: .5 sec @ 60°, .40 sec @ 60° non-proportional
          Output Torque: 91 oz-in @ 4.8V, 110 oz-in @ 6V
          Weight: 1.2oz (34g)
          Length of servo lead: 6" (152mm)

COMMENTS: A retract servo is a very specialized servo. It is non-proportional,
            going 180°, "lock to lock", and specifically made for mechanical
            retracts to lock the gear in the up and down positions.
            They DO NOT have any means of end point adjustment and can not be
            adjusted by ATV on a transmitter. They are only able to go 180°
            and provide full maximum available torque at the two end points.
            This is their whole purpose and intentional design, but if someone
            has a unique design situation where they need other than 180°
            available, they must use a proportional servo, not a retract servo.
            They are specifically designed to withstand constant holding loads
            in the UP and DOWN positions, unique to the use of mechanical
            retracts.
            Pneumatic retracts DO NOT use retract servos. A proportional
            standard or mini servo is used to move the air valve back and forth

                                                                      js 4/5/94
                                                                          ir/jl



– If you need more information, use these Tower Hobbies resources –

Click Here: Manufacturer's Product Web Page
E-mail: info@towerhobbies.com
Web Site: http://www.towerhobbies.com/
Phone: 217-398-8970


 
Postal Address:
Tower Hobbies
PO BOX 9078
CHAMPAIGN, IL 61826  








Click here for Units of Measure Conversion Calculators