This is the Ofna Engine Tuning Screwdriver.
FEATURES: Round handle is constructed of serrated aluminum for sure grip,
shaft is chromed steel.
Narrow 0.12" (3mm) blade fits inside needle sockets to easily set
mixtures.
Top of screwdriver unscrews and functions as a piston stop that can
be threaded into the hole to prevent crankshaft from
turning when tightening propellers or installing clutch assemblies.
The top section has threaded storage for 1 (not included).
INCLUDES: One Ofna Engine Tuning Screwdriver.
One piston locking tool
SPECS: Total Length: 6.14" (156mm)
Shaft Length: 3.07" (78mm)
Blade Width: 0.12" (3mm)
Thread Diameter: 0.24" (6mm)
COMMENTS:
For light-duty engine work, the piston locking tool included with this
tool is all you need to prevent the crankshaft from rotating. To use the
tool, simply remove the and screw the tool into place to hold
the piston at bottom-dead-center.
*** Do NOT use this type of tool for heavy-duty tightening or loosening
as you may overstress the piston, conrod, or wristpin. ***
Updated JBM 11-17-05
JXS 4/12/02
ir/kh
– If you need more information, use these Ofna resources – |
E-mail: help@ofna.com
Web Site: http://www.ofna.com/
Phone: 949-586-2910
|
|
Postal Address:
Ofna
7 VANDERBILT
IRVINE, CA 92618
|
Click here for Units of Measure Conversion Calculators