View Larger Picture

E-mail This Page To A Friend

            This is the electric powered Ready To Run 1/10 scale
                     Tamiya Ferrari FXX On-Road Car.
         This vehicle is part of Tamiya's XB (Expert Built) series.

FEATURES: Chassis:         Plastic tub TT-01 design
          Drive:           Four wheel shaft drive
          Radio:           Tamiya Expec TTU-03 AM pistol-grip w/servo reverse,
                             steering and throttle trims and standard servo
                             (transmitter does not have a charge jack)
          Receiver:        Tru-02 AM 2 Channel on 27MHz
          Motor:           540 motor with pre-attached leads (bullet style)
          Ball Bearings:   Installed in differentials, bushings in wheel hubs
          Shocks:          Friction, plastic body
          Gearbox:         Sealed, front and rear
          Differentials:   Bevel gear, ball bearing equipped
          Transmission:    Single speed
          Body:            .03" (.8mm) polycarbonate, painted and trimmed
          Tires:           2.6" (65mm) outer diameter
                           1"    (25.4mm) wide racing radial type
          Wheels:          Black 2" (51mm) outer diameter
          Speed Control:   TEU-101BK electronic, w/reverse & standard connector
          Bumper:          Foam front bumper
          Suspension:      Four wheel independent double wishbone
          Camber Tie Rods: Fixed, non-adjustable,
          Steering Tie Rods: Fixed, non-adjustable
          Steering:        Bell-crank type
          Servo Saver:     Included

INCLUDES: Tamiya Ferrri FXX on-road car, pistol-grip transmitter, receiver,
            540 motor, ESC, painted body, tires, foam bumper, spoke wheels
            wheels, 19 tooth pinion gear, 61 tooth spur gear and instructions

REQUIRES: Radio Batteries: 8 AA size (for transmitter)
          Battery:         6 cell flat pack with standard connector
          Charger:         AC/DC Timed or Peak for 6-cell battery
          Misc. Items:     Building and track equipment

SPECS:      VEHICLE-
          Length:        15" (381mm)
          Width:        7.5" (190mm)
          Height:       4.3" (110mm)
          Weight:       3.1lbs. (1490g) with battery, speed control, motor and
                         radio equipment (approzimate)
          Wheelbase:    10.1" (257mm)
          Tread: Front-  6.3" (159mm)
                 Rear-   6.2" (157mm)  side-to-side at wheel centers
          Gear Ratio:    8.35:1
          Tires- Width: 1" (26mm)
                        Inner Diameter: 1.8" (46mm)
                        Outer Diameter: 2.6" (65mm)
             BODY-
          Length:        18" (456mm)
          Width:        7.5" (190mm)
          Height:         4" (102mm)

COMMENTS: For Replacement Ball Bearings use:
            Qty   Size      Location                       Bearing Set Qty
             12   5 x 11mm  front & rear diff gears, hubs    DTXC1547    6
              4   8 x 12mm  front & rear diff gears          DTXC1597    2

                  Body is painted Red with a White stripe

                                                                   jxs 10/17/06
                                                                         ir/jxs



– If you need more information, use these Tamiya resources –

E-mail: us_support@tamiya.com
Web Site: http://www.tamiya.com/
Phone: 800-826-4922


 
Postal Address:
Tamiya
36 DISCOVERY WAY SUITE 200
IRVINE, CA 92618  








Click here for Units of Measure Conversion Calculators