E-mail This Page To A Friend

          This is the electric powered, radio controlled, 1/10 scale
                  Custom Works Aggressor Super Speedway Kit.

FEATURES: Chassis: Solid one-piece carbon fiber .100" (2.54mm) thick
          Bumper: Self adhesive front and side foam, movable to keep body tight
            on car
          Wheelbase Position: Three lengths possible with easy change positions
            for width on each front end clip, standard and wide wheel hubs are
            included
          Rear Pod Design: Allows for centered and off-set pod configurations-
            adjustable to allow extra soft set-up for extremely bumpy tracks
            adjustable rear steer clip allows 0 and 1/2° degree pod angle
          Battery Position: Adjustable
          Ball Bearings: Full set included
          Suspension: Adjustable oil-filled coil over rear shock
          Caster: Adjustable, simple set screw adjustment, caster/toe-in refers
            to the angle of the front suspension when viewed from the side of
            the car in relation to the chassis
          Camber: Adjustable, camber refers to the angle of the tops of the
            tires from vertical when viewed from front or behind vehicle,
            upper suspension mount allows for four positions of camber gain
            settings

INCLUDES: Custom Works Aggressor On-Road Car Kit with standard and wide hubs,
            axle spacers, front foam bumper, body posts, bearings, 96 tooth
            spur gear (64 pitch) and photo illustrated instructions

REQUIRES: Radio: 2-channel with 1 servo - FUTK01** or modeler's choice
          Motor: 540 size of modeler's choice
          Electronic Speed Control: DTXM1059 or modeler's choice
          Battery: 4-6 cell side by side pack
          Battery Charger: DTXP4005 or modeler's choice
          Tires: CSWC6281
          Pinion Gear: 64 Pitch of modeler's choice (KIMC0430 would be a good
           starting point for the suggested motor and included spur gear)
          Body: Modeler's choice

SPECS:    Specs such as length, weight, wheelbase and weight were not provided
            by manufacturer

                                                                  kpm02/06/2007
                                                                         ir/jxs



– If you need more information, use these Custom Works resources –

E-mail: customworkstech@aol.com
Web Site: http://www.customworksrc.com/
Phone: 704-489-8147


 
Postal Address:
Custom Works
760-B CROSSPOINT DRIVE
DENVER, NC 28037  








Click here for Units of Measure Conversion Calculators