View Larger Picture

Instruction Manuals:	Manual 1 (174 KB)
Tower Catalog Page:	202
E-mail This Page To A Friend

          This is the BT-24EI Gasoline Airplane Engine from Fuji Imvac.

FEATURES  Electronic ignition offers full 30° timing sweep for better idle and
            top end performance
          Dual ball bearings on both the crankshaft and connecting rod
          Easy straight-out throttle linkage
          Compact muffler fits into cowlings easier
          Walbro carburetor features easy-to-use butterfly choke valve
          THREE YEAR warranty

INCLUDES: One BT-24EI Gasoline Airplane Engine from Fuji Imvac with Champion
            RCJ6Y resistor spark plug, plug wrench, muffler, motor mount,
            instruction manual, prop flange with washer, prop bolt, friction
            ring, 4mm hex wrench and Electronic Ignition System

REQUIRES: 2-cycle oil, FJIP9910
          Battery for ignition
          Engine ON/OFF switch
          Propeller: 16x8 (APCQ1608), 16x10 (APCQ1610) or 16x10 carbon prop

SPECS:    Displacement:     1.46 cid (24cc)
          Practical RPM:    1,200-11,000 RPM
          Output:           2.2 bhp @ 10,000 RPM
          Weight: 3.20 lbs (1,453 g) with muffler
                  2.95 lbs (1,342 g) without muffler
          Fuel ratio, gas/oil mix: 100-150:1, (1:50:1 for break-in)
          High Speed Needle Setting: Open ¾ turn from closed, ±¼ turn in Winter
          Low Speed Needle Setting: Open 1/3/8 turn from closed, ±¼ turn
            in Winter) NOTE-It is not necessary to change needle settings if
            engine runs smoothly. Normally only the "H" needle will need
            adjustment from time to time and only a small amount.
          On-Center Mounting Holes, Side to Side: 2.7"  (70mm)
          On-Center Mounting Holes, Top to Bottom:  3"  (76mm)
          Engine Height, Including Spark Plug:    6.5" (165mm)
          Length from Muffler to Carb Opening:   5.75" (146mm)
          Length from Mounting Plate to Magneto Rotor: 4" (102mm)
          Length from Crankshaft to Magneto Rotor:   4.5" (114mm)

COMMENTS: Fuji Imvac is NOT related to the original Fuji engines sold by MECOA

                                                                   jxs 01/22/07
                                                                         ir/jxs



– If you need more information, use these Fuji Imvac resources –

Click Here: Manufacturer's Product Web Page
E-mail: enginesupport@hobbico.com
Web Site: http://www.fuji-imvac.com/
Phone: 217-398-8970


 
Postal Address:
Fuji Imvac
3002 N. APOLLO DRIVE, SUITE 1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators