View Larger Picture

E-mail This Page To A Friend

    This is the DuraTrax/SuperTigre G-27CS Super Start Ready Racing Engine
          for the DuraTrax Warhead Evo and the Raze Buggy and Truggy.

FEATURES: Pre-installed back plate and nut for DuraTrax Super Start operation
          ABC cylinder construction-"A"luminum piston,"B"rass cylinder liner
            that is "C"hrome plated
          Dual ball bearing-supported SG (pilot) style crankshaft
          Dual needle Slide Valve Carburetor
          Machined aluminum blue cylinder head
          Rear exhaust
          Three year limited warranty

INCLUDES: DuraTrax/SuperTigre G-27CS Super Start Ready Racing Engine with glow
            plug

REQUIRES: DuraTrax Kwik-Pit Super Start (DTXP6001)
          **If using with the Warhead Evo, the following items are required;**
            Duratrax Super Start (DTXP6018)
            Clutch Nut (DTXC7152)
            Pull Start (DTXG0756)
            Super Start Backplate (DTXP6033)
          Fuel: Car fuel blend with 20% nitromethane content
          Glow starter, plug wrench and track equipment

SPECS:    Displacement: .27 cu in (4.4cc)
          Bore:   .72 in (18.2mm)
          Stroke: .67 in   (17mm)
          Horsepower: 2.5 hp at 30,000 RPM
          Practical RPM Range: 3,000-35,000
          Weight: 14.1oz (400g)

          Distance Between Mounting Holes Same Side:     .83" (21mm)
          Distance Between Mounting Holes Opposite Side: 1.4" (37mm)
          Height from Bottom of Mounting Tabs/Top of Cylinder Head: 3.6" (92mm)
          Height from Bottom of Crankcase to Top of Cylinder Head: 4.2" (107mm)
          Width at Mounting Tabs: 1.8" (46mm)
          Distance from Pull Start to Front Bearing:     3.3" (84.5mm)
          Distance from Pull Start to End of Crankshaft: 3.9"   (99mm)
          Diameter of Exhaust Opening:    .59"   (15mm)
          Diameter of Carburetor Opening: .56" (14.2mm)

          Factory Needle Settings:
           High Speed Needle: 4.5 turns OUT from closed
           Low Speed Needle: 12.5 turns OUT from closed
                             (1 turn OUT from flush with ball link body)

COMMENTS: This engine is intended for use in the DuraTrax Warhead EVO and the
            Raze Truggy and and Buggy and does not include an instruction
            manual.
            Refer to engine installation and maintenance sections in each
            manuals.

                                                                    jxs 6/19/07
                                                                         ir/jxs
                                                               updt lmm 3/26/09



– If you need more information, use these DuraTrax resources –

E-mail: carsupport@duratrax.com
Web Site: http://www.duratrax.com/
Phone: 217-398-8970


 
Postal Address:
DuraTrax
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators