This is the glow powered, radio controlled ready-to-run
Traxxas Nitro Rustler 1/10 scale Stadium Race Truck.
FEATURES: Chassis: T-6 aluminum anodized blue with fiber composite upper plate/
front brace
Radio: Traxxas TQ 27MHz AM with high torque steering servo, trim and
servo reverse, transmitter does not have charge jack
Engine: Traxxas 2.5 racing engine with EZ-Start electric starter,
slide valve carb, two glow plugs, air filter and cylinder head
protector, battery and charger for EZ-Start
Exhaust: Composite tuned pipe with aluminum header
Drive: Rear wheel with telescoping U-joint drive shafts
Body: Pre-painted, pre-cut polycarbonate body
Shocks: Four composite bodied oil-filled
Slipper Clutch: Adjustable
Suspension: 4-wheel independent
Transmission: Ball bearing equipped, Magnum 281
Differential: Planetary gear with steel internal gears
Fuel Tank: 2.5oz (75cc) with flip-top lid and primer bulb
Brake: Composite disc type
Spur Gear: Nylon, 70 tooth 32-pitch
Wheels: Chrome 2.0" (51mm) wide, 2.8" (71mm) diameter five-split
spoke Jato
Tires: Front, ribbed 2.8" (71mm) inner diameter, 2" (51mm) wide
Rear, Traxxas Alias 2.8" (71mm) inner diameter, 2" (51mm) wide
Caster: Adjustable, caster/toe-in refers to the angle of the front
suspension when viewed from the side of the car in relation to thei
chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle
INCLUDES: Assembled Nitro Rustler with TRX-2.5 racing engine and ,
EZ-Start electric starter, painted body with rear wing, decals,
TQ pistol grip radio, tuned pipe, instruction sheet, extra glow
plug, fuel bottle, tools, battery & charger
REQUIRES: "AA" Batteries: 12 (8 for transmitter and 4 for receiver)
Fuel: Car fuel with 10-15% content
Misc. Items: Building and track equipment
SPECS: Length: 17-1/4" (438mm)
Front Track: 12-1/2" (318mm)
Rear Track: 12-3/8" (314mm)
Weight: 60 ounces (1701g) without radio
Height: 6" (152mm)
Wheelbase: 11.3" (287mm)
Fuel Capacity: 2.5 ounces (75cc)
Engine: TRX 2.5 racing w/EZ Start System
Gear ratio: Adjustable 8.43:1 to 12.64:1
Differential: Planetary gear
Brake: Disc
Chassis: Double-decker (bottom aluminum,top composite)
Spur gear: Nylon, 70 tooth 32-pitch
Clutch bell: 20 steel tooth
Caster block: Front 30 degrees
COMMENTS: For Replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set
4 5x11mm Front Wheels 2 DTXC1547
4 5x11mm Rear Wheels 2 DTXC1547
6 5x11mm Transmission 3 DTXC1547
2 5x11mm Clutch Bell 1 DTXC1547
For complete bearing set use DTXC1326.
REPLACING EZ STARTER WITH STANDARD RECOIL STARTER
To convert the EZ starting to a standard "pull starter", purchase
part numbers TRAG5170, TRAP5211 one-way bearing, 4 3x8mm machine
screws, take out the three bolts on the EZ-Starter, clip the wires
on the EZ-Starter, and install recoil pullstart.
Available with the following radio channels and body colors;
TRAC84A2 Red with gray, orange and yellow accents
TRAC84A4 Gray with red, orange and yellow accents
TRAC84A5 Blue with gray, orange and yellow accents
TRAC84A6 Gray with blue, orange and yellow accents
jxs 6/11/07
ir/jxs
Upd OA 10/24/07
Click here for Units of Measure Conversion Calculators
|