E-mail This Page To A Friend

     This is a 1/48 Plastic F-117A Stealth Fighter from Academy Plastics.
                          It's for ages 10 and up.

     The F-117A is built mostly of aluminum and some titanium.  The flat
angles, or facets, are designed to reflect radar everywhere except back to the
transmitter receiver.  The stealth is also covered with Radar Absorbent
Material (RAM) to help ward off radar detection.  The F-117A is powered by two
General Electric F404-GE-F1D2 engines and carries all weaponry internally,
the most often used being the GBU-27A Paveway III Bombs.

FEATURES: Plastic pieces attached to sprues and molded in black.
          The surface of the plane is decorated with fully engraved panel
            lines and sleek anti-radar details.
          Highly detailed cockpit interior, landing gear, and bomb bay.
          Flap/aileron assembly is accurately reproduced.
          Armament includes one GBU-27A Paveway III bomb that fits in the
            fuselage and attaches to a detailed bomb rack.
          Clear plastic canopy allows close inspection of cockpit and may be
            Modeled in an open or closed position.
          Detailed pictorial instructions guide you through assembly.

MARKING
OPTIONS:  One Decal Sheet with Markings for Two Aircraft:
            1: Lockheed F-117A "Toxic Avenger" Col. Al Whitley, 37th TFW
            2: Lockheed F-117A; Lt.Col. Ralph Getchell 415th TFS No.790
          Airframe Colors:
            1: Flat Black
            2: Flat Black
          Detail Colors:
            Flat White, Silver, Neutral Gray, Olive Drab, Red, Metallic Gray

INCLUDES: One 1/48 Plastic F-117A Stealth Fighter

REQUIRES: Assembly
          Cement
          Paint (see MARKING OPTIONS)
          Brushes
          Sprue Cutter
          Modeling Knife
          File or Emery Board
          Scissors
          Tweezers
          Water for Decals
          Glue Tips or Toothpicks
          Cloth
          Adult Supervision

SPECS:    Scale:    1/48
          Length: 13-1/4" (33.6cm) (approximately)
          Width:  10-3/4" (27.2cm) (approximately)
          Height:  2-1/2" (6.1cm)  (approximately)

COMMENTS: Keep small parts and sharp edges away from children.
          Care should be taken when using tools and modeling knives.
          Modeling paint should only be used by an adult in a well-ventilated
            area.
                                                                     jtt 8/8/00
                                                                          ir/jl



– If you need more information, use these Academy resources –

E-mail: mrcsupport@modelrectifier.com
Web Site: http://www.academy.co.kr/
Phone: 732-225-2100


 
Postal Address:
Academy
C/O MODEL RECTIFIER CORPORATION
80 NEWFIELD AVENUE
EDISON, NJ 08837  








Click here for Units of Measure Conversion Calculators