This is a Basic Train Engineer Walk-Around Control System from Aristo-Craft.
It's for experienced collectors.
FEATURES: 2-piece set consists of the transmitter (Tx) and the receiver (Rx).
Allows operation of any DC powered model railroad train as a
"wireless walk-around" control system without any modifications to
existing power supplies or locomotives.
Fully compatible with any gauge and scale of DC model train.
Can be used with almost any DC power pack of 2.5A or less.
Easy installation and operation - only 4 wires need to be connected.
Operational distances of "100" are possible between transmitter and
receiver and no "line of sight" is required.
Set can be used either inside or outside if receiver is protected.
Flexible antenna.
"Momentum function" built into controls so that "jack rabbit" starts
and stops are eliminated.
No programming is necessary to begin operation.
Clear instructions, a limited warranty, and servicing available.
INCLUDES: One Basic Train Engineer Walk-Around Control System
REQUIRES: DC Power Pack
Phillips Head Screwdriver
9V Alkaline Battery
Adult Assistance/Supervision
SPECS: Transmitter (Tx): Frequency: 27MHz
Band Modulation: FM (Code Type)
Power Supply: 9V Alkaline Battery (Internal)
Receiver (Rx): Frequency: 27MHz
Type of Emission: FM (Code Type)
Input Voltage: 12V - 22V DC
Output Control Current: 2.5A
COMMENTS: Do not operate more than one G-scale locomotive.
Do not apply AC power to the train engineer receiver.
Do not connect any other power source to the track.
Complies with Part 15 of the FCC rules.
Keep away from small children.
san 10/6/00
ir/jl
– If you need more information, use these Crest resources – |
Web Site: http://www.aristocraft.com/
Phone: 973-351-9800
|
|
Postal Address:
Crest
C/O ARISTO-CRAFT/POLKS MODELCRAFT
698 SOUTH 21ST STREET
IRVINGTON, NJ 07111
|
Click here for Units of Measure Conversion Calculators
Yes
E-mail This Page To A Friend
