This is the 1/10 scale electric powered, radio controlled, Ready To Run
HPI Sprint 2 Sport on-road Touring Car with the Impreza Body.
_
FEATURES: Chassis: Reinforced molded nylon chassis, upper deck and shock towers
Drive: Four wheel
Drive Type: Urethane belt (dual belt)
Motor: Firebolt 15 Turn (HPI #1146 we don't stock)
Radio: HPI (made by Airtronics) AM TF-1 pistol grip with steering and
trim, and servo reverse (no dual rate or charge jack),
RF-1 2 channel receiver, and one SF-1 standard servo
Electronic Speed Control: SC-15 forward & reverse (specs unavailable)
Full ball bearings: Located in transmission and bell crank, rubber
sealed bearings in wheels, 14 total
Shocks: Four oil-filled, plastic bodied
Differentials: Planetary gear type with metal outdrives, sealed
Transmission: Ball bearing equipped and capable of handling modified
motors down to 10 turns
Wheels: 6 spoke chrome 1" (26mm) wide, 2" (51mm) diameter, 6mm offset
at rear, 3mm offset at front
Tires: X-pattern D compound 1" (26mm) wide 2.5" (64mm) outer diameter
Bumpers: Front, foam
Body: Fully trimmed and painted with rear wing and decals applied
Suspension: Fully adjustable
Caster: Adjustable, caster/toe-in refers to the angle of the front
suspension when viewed from the side of the car in relation to the
chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle
Ackerman: Adjustable, Ackerman describes the effect of the inside
front wheel turning tighter than the outside front wheel
Steering: Bell-crank type with servo saver
Belt Tensioner: Adjustable
INCLUDES: HPI Sprint 2 on-road Touring Car with oil-filled shocks, 15 turn
motor, Electronic Speed Control, painted body, tires, foam inserts
wheels, 28 tooth pinion gear, 87 tooth spur gear, instructions, 2-
channel radio, 2 and 3° rear toe-in blocks, 4 and 6° front caster
and Sprint 2 decal sheet
REQUIRES: AA batteries: 8 for transmitter
Battery Pack: 6-cell stick or saddle configuration
Charger: Required to charge 6-cell pack
Misc. Items: Building and track equipment
SPECS: VEHICLE-
Length: 17" (431mm)
Width: 7.5" (190mm)
Height: 5" (127mm)
Weight: 3.1lbs (1425g) Ready-To-Run
Wheelbase: 10" (254mm)
Front Tread: 6.5" (166mm)
Rear Tread: 6.9" (175mm) side-to-side at wheel centers
Front Track: 7.3" (186mm)
Rear Track: 7.75" (197mm)
Ground Clearance: 0.41" (10.5mm)
Gear Ratio: 6.62:1
Tires- Front and Rear: 1" x 2.5" (26mm x 64mm)
BODY-
Length: 17" (432mm)
Width: 8.2" (208mm) at rear wheels (widest point)
7.25" (184mm) ahead of front wheels (thinnest point)
Height: 3.5" (89mm)
COMMENTS: For Replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set
4 5x10mm Front Wheels 2 DTXC1535
4 5x10mm Rear Wheels 2 DTXC1535
2 4x8mm Servo Saver 1 DTXC1511
2 5x8 Fr Diff Shafts 1 DTXC1523
2 5x8 R Diff Shafts 1 DTXC1523
2 10x15mm Fr Ball Diff 1 DTXC1595
2 10x15mm R Ball Diff 1 DTXC1595
The difference between the Sprint 2 and the Sprint 2 Sport is the
Sprint 2 includes a charger, battery pack, a transmitter with dual
rates and a charge jack, a different motor and a different speed
control.
kpm11/07/2007
ir/jxs
Click here for Units of Measure Conversion Calculators
| 
E-mail This Page To A Friend
Primary Accessories
Primary Accessories
