View Larger Picture

E-mail This Page To A Friend

       This is HPI's Nitro Star F4.6 .28 size Engine With Pullstarter.
       Can be installed in the HPI Savage X 4.6 Monster Truck, HPID67**
             for those who prefer an engine with a pull starter.

FEATURES: Composite construction slide valve, 7.5mm 3 needle carburetor, high
            speed needle, idle screw and low speed needle are set flush with
            the carburetor body for factory settings
          8 port chrome plated brass sleeve
          ABC cylinder construction, "A"luminum piston with a "B"rass cylinder
            that is "C"hrome plated
          Purple anodized billet aluminum heat sink head
          Round rear exhaust port
          Cast aluminum crankcase with heatsink fins
          Machined pilot shaft crankshaft with collet preinstalled
          Knife-edge billet aluminum connecting rod with dual bushings.
          High flow 2-stage air filter dramatically reduces intake
           restriction as it smoothes and straightens air flow
          Two year limited warranty

INCLUDES: Nitro Star .28 F4.6 glow engine
          Glow Plug - HPI R5 cold plug (HPIG1504 for a replacement)
          Dual Stage Air Filter (HPIC7198 for replacement)
          Instructions and exploded views

SPECS:    Height/bottom of Mounting Flanges/top of Cylinder Head: 4" (101mm)
          Height/bottom of Crankcase/top of Cylinder Head: 4.5" (114mm)
          Length from Pull Starter to Front Bearing: 3.3" (84.5mm)
          Length from Pull Starter to end of Crankshaft: 4.6"  (117mm)
          Width at Mounting Flanges: 1.81" (45.9mm)
          Mounting Hole Center Same Side: .82" (21mm)
          Mounting Hole Center Opposite Side: 1.42" (36mm)
          Bore: 18.68mm
          Stroke: 16.6mm
          Horsepower:  2.9 @ 32,000 RPM
          Crankshaft diameter: 5mm (clutch bell area)
          Crankshaft diameter: 6.7mm (threaded portion)
          Displacement: 4.6cc (.28 ci)

REQUIRES: Glow Fuel: 20-25% nitro content
          Glow starter
          Tuned pipe
          Manifold

COMMENTS: This engine can be converted from recoil to Roto Start with
          HPIP7126. If the modeler only wants a Roto Start Backplate they can
          can purchase HPIG7127.
                                                                   jxs 11/19/07
                                                                         ir/jxs



– If you need more information, use these HPI Racing resources –

E-mail: support@hpiracing.com
Web Site: http://www.hpiracing.com/
Phone: 949-753-1099


 
Postal Address:
HPI Racing
70 ICON STREET
FOOTHILL RANCH, CA 92610  








Click here for Units of Measure Conversion Calculators