View Larger Picture

Tower Catalog Page:	141
E-mail This Page To A Friend

       This is the Novak Mongoose 8.5 Micro Brushless System with the
             Three-80 8.5 Turn Motor and the Mongoose Micro ESC
                         for 1/18 and 1/16 scale Cars.

FEATURES:   ESC-
          Compatible with 380-size or smaller brush motors and Novak Three-80
            series brushless motors
          Three brushless throttle profiles designed for micro vehicles and
            one brushed throttle profile (features built-in Auto Detect Brush
            Mode)
          One touch programming and four status LEDs
          2S & 3S Li-Po cutoff circuitry can be activated in any throttle
            profile
          Gold-plated PCB direct-solder wiring tabs
          Plug-in input harness and user-replaceable switch harness
          Replaceable 16GA silicone battery and motor wire
          Water-resistant case and factory installed heat sink
            10.5 Turn Motor-
          Recommended for racers wanting the fastest Novak Micro Brushless
            system
          Sensor commutation design provides smooth braking and controlled
            bursts of power
          Sintered Neodymium rotor for maximum acceleration
          120 day limited warranty on both components

INCLUDES: Novak Mongoose Electronic Speed Control and Novak Three-80 8.5
            turn Brushless Motor and Instruction Manual

REQUIRES: Installing in vehicle and connecting to receiver and battery

SPECS:      ESC-
          Input Voltage: 2-3 Li-Poly cells or 4-9 Ni-MH/Ni-Cd cells (1.2V/cell)
          Forward/Reverse: FWD/BRK/REV (brushless mode); FWD/BRK (brush mode)
          Motor Limit: any Novak Micro (brushless); any 380-size (brushed)
          Size: 1.15" x 0.95" (29 x 24.3mm)
          Weight: 0.77 oz. (21.7 grams)
          Rated & Braking Current: 40 amps per phase (brushless/brush)
          Power Wires: 16-gauge
          BEC: 6.0 volt/2.0 amps
          Voltage Cut-Off: 6.25 volts (2S), 9.375 (3S) [when Li-Poly Cut-Off
            Circuitry is enabled]
          Motor Plug: 2 mm connectors
            Motor-
          Input Voltage: 2-3 cell Li-Po or 4-9 Ni-MH/Ni-Cd cells (1.2 V/cell)
          Watts: 210
          Kv (unloaded): 9000
          Size: 380 size: 1.02" D x 1.48" L (26 D x 37.7 L mm)
          Motor Weight with Wires: 2.54 oz. (72 grams)
          Shaft Diameter: 1/8" (accepts all existing pinion gears)
          Bearing Size: Oversized (1/2" x 3/16") Front; Standard Rear (7mm x
            3mm)
          Magnet: Sintered Nickel-plated Neodymium (one-piece, multi-pole
            cylindrical)

COMMENTS: Novak Pinion Gear Sets compatible with this system include;
            NOVC5200 11/12/13T    NOVC5210 0.5 11/12/13T
            NOVC5201 14/15/16T    NOVC5211 0.5 14/15/16T
            NOVC5202 17/18/19T    NOVC5212 0.5 17/18/19T

                                                                    jxs 6/20/08
                                                                         ir/jxs



– If you need more information, use these Novak resources –

E-mail: cs@teamnovak.com
Phone: 949-833-8873


 
Postal Address:
Novak
17032 ARMSTRONG AVENUE
IRVINE, CA 92614  








Click here for Units of Measure Conversion Calculators