This is the Complete Regulating Smoke System from Perry.
FEATURES: Pump is intended for gasoline or diesel fuel and for model airplane
smoke units.
System operates independently of engine's fuel system.
Remote enables user to accurately control the smoke out-
put depending on engine size, muffler and amount of smoke desired.
INCLUDES: One gasoline/smoke regulator pump
One check valve
One remote smoke valve
One remote
One crankcase pressure tap with fitting
Four 2x25mm slot head screws
Four 2mm nuts
Eight 2mm washers
Two pieces of fuel tubing (one Yellow, one Orange)
One pump clamp
One instruction sheet
REQUIRES: Smoke fuel tank, size depends on room inside aircraft, tank must also
be safe for use with gasoline.
Smoke type muffler, depending on engine size and brand.
Standard servo and extra radio channel to operate remote smoke valve.
COMMENTS: This pump is recommended for carbs using two needle valves, one for
High Speed and one for Idle. Air-bleed carbs and Perry non-pump
carbs will run rich in the mid-range and are not recommended for
use with this pump.
The Remote (PERG4430), remote smoke valve (PERG7023)
and the pump (PERG4610) are available seperately.
JXS 10/04/00
ir/jl
– If you need more information, use these Perry resources – |
Web Site: http://www.conleyprecision.com/
Phone: 630-858-3160
|
|
Postal Address:
Perry
825 DUANE STREET
GLEN ELLYN, IL 60137
|
Click here for Units of Measure Conversion Calculators