View Larger Picture

On-line Videos:	Video 1 (31.9 MB) Video 2 (4.2 MB)
Product Reviews:	Review 1 Review 2 Review 3

               This is the Futaba Mode 2 Airplane Version
           10C Transmitter and R6014FS 14-ch Receiver with the
                             2.4GHz FASST system.
                              No Servos Included.

           **This has been replaced with the 10CAG, FUTK9255.**

This version is Mode 2-Left Hand Throttle and Right Hand Elevator, USA Standard
  **For European Standard Mode 1-Right Hand Throttle and Left Hand Elevator**
                              **order FUTK9252**

        This airplane version which will default to airplane settings,
with mode 2 stick operation when powered up and has a ratcheted throttle stick.

FEATURES: Futaba's FASST (Futaba Advanced Spread Spectrum Technology) shifts
            very quickly virtually eliminating signal conficts and
            interruptions unlike other 2.4GHz systems that only stay on one
            or two frequencies
          Dual antenna diversity enables FASST system to automatically and
            seamlessly select the best reception between the two antennas
            built into the receiver ensuring that the aircraft stays under
            constant control of transmitter regardless of altitude
          Pre-Vision Packet Screening technology scans incoming data for
            potential problems and applies sophisticated error correction
            techniques for solid impenetrable link with model
          Easy Link system features a unique ID code in the transmitter that
            links to the receiver insuring that receiver only follows commands
            from this transmitter-with over 134 million possible codes there
            is no chance for a conflict
          No hassle Fail Safe programmed through transmitter-no complicated
            set-up steps or binding plugs
          When performing a ground check, the Power Down function allows
            modeler to reduce power from up to 50+ paces away-like retracting
            the antenna on a conventional transmitter
          Purpose built custom IC chips for key functions; no off-the-shelf IC
            chips
          One year limited warranty

INCLUDES: Futaba 10C Transmitter with Module
          NT8S700B 9.6V 700mAh NiCd Transmitter Battery , FUTM1460
          NR4J 600mAh NiCd Receiver Battery, FUTM1280
          FBC-19B RX, TX Wall Charger, FUTM1830
          R6014FS Receiver, FUTL7644
          Switch Harness
          8" (203mm) Servo Extension
          Neck Strap, FUTM5690

REQUIRES: Servos depending on type of aircraft

SPECS:    Transmitter;
            Power Supply: 9.6V NT8S700B NiCd battery
          Receiver;
            Receiving Frequency: 2.4GHz
            Power Requirement: 4.8 - 6V
            Current Drain: 70mA
            Size: 2.06 x 1.48 x 0.63" (52.3 x 37.5 x 16.0mm)
            Weight: 0.72oz (20.8g)

COMMENTS: This radio is available in other default modes, below are the
             three options:
          FUTK9251   HELI Mode 2
          FUTK9252   AIR Mode 1
          FUTK9253   HELI Mode 1

          This system can also be operated on 72MHz by purchasing the
            Transmitter Antenna (FUTM5110), and the 72MHz Module (FUTL1516)
            and using a compatible receiver.

                                                                    jxs 2/07/08
                                                            updated jpg 4/23/08
                                                               updt jxs 8/28/08
                                                             updated jpg 2/3/09



– If you need more information, use these Futaba resources –

E-mail: support@futaba-rc.com
Web Site: http://www.futaba-rc.com/
Phone: 217-398-8970


 
Postal Address:
Futaba
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators