This is the Ofna Force .12 Side Force Engine w/Pull Starter.
FEATURES: 7 horizontal cooling fins on the machined Red aluminum head
Slide Valve w/flat head screwdriver High-Speed adjustment
Pre-set Low Speed
INCLUDES: One assembled .12 size S engine w/Slide Valve Carb, pull starter
and drive washer with collet
One set of instruction/warranty/parts list information sheets
REQUIRES: : recommend OS Max #8 or McCoy #MC59 (with 2 copper washers)
Starter
Wrench
Fuel: 20% is recommended such as Cool Power or O-Donnell
Fuel Bottle
Engine Tuning Screwdriver
Air Filter and Oil
SPECS: Horsepower: .55 BHP at 29,000 RPM
RPMs: 3,000 - 30,000 practical range, 38,000 max
Length: 74mm (front of crankcase to back of pull start)
Height: 86mm (3.40")(bottom of pull start to top of head)
Mounting Holes on opposite side: 1.22" (31mm)
Mounting Holes on center front to back: .48" (12.1mm)
Distance from drive washer to end of starter case: 3.31" (84mm)
Width at widest point (mounting flanges): 39mm (2.54")
High Speed Needle: 2½ turns out from closed
Low Speed Mixture: initially flush with carb housing, turn clockwise
using small 1/8th" turns to lean out mixture.
Maximum running temperature: 250°F (do not exceed this temperature,
however a lower temp is better).
cmc 03/16/02
ir/kh
updt jxs 1/12/04
– If you need more information, use these Ofna resources – |
E-mail: help@ofna.com
Web Site: http://www.ofna.com/
Phone: 949-586-2910
|
|
Postal Address:
Ofna
7 VANDERBILT
IRVINE, CA 92618
|
Click here for Units of Measure Conversion Calculators
|