View Larger Picture

Tower Catalog Page:	114
E-mail This Page To A Friend

              This is the electric powered, radio controlled,
        Associated Factory Team 12R5 1/12 scale On-Road Pan Car Kit.

FEATURES: Chassis: 0.10" (2.5mm) thick woven carbon fiber with top plate,
            wide rear pod for easy installation of brushless motors
          Drive: Two wheel rear
          Ball Bearings: Full set included
          Differential: Ball type
          Motor Mount: Factory Team blue machined aluminum
          Shock: Single aluminum body center shock with through-shaft design
            for equalized damping throughout the full stroke with no unwanted
            rebound, shock also controls chassis droop and adjusts with a
            turnbuckle wrench, woven carbon fiber shock tower with four
            mounting positions
          Suspension: Pivot ball link rear suspension allowing independent
            adjustments for chassis roll, bump and alignment, active strut
            front end with symmetric components and adjustable caster and
            track width
          Bumper: Foam front
          Caster: Adjustable, caster/toe-in refers to the angle of the front
            suspension when viewed from the side of the car in relation to the
            chassis
          Camber: Adjustable, camber refers to the angle of the tops of the
            tires from vertical when viewed from front or behind vehicle
          Ackerman: Adjustable with spacers, Ackerman describes the effect of
            the inside front wheel turning faster than the outside front wheel
            during turns

INCLUDES: Associated Factory Team 12R5 Pan Car Kit with decals, double sided
            tape, 96 T spur gear illustrated instruction manual

REQUIRES: Radio: 2-channel with mini steering servo
          Electronic Speed Control: For stock or modified motor
          Motor: 540 size
          Battery: 4-cell sub-C 2x2 flat configuration
          Battery Charger: Peak type for selected battery
          Wheels and Tires: 1/12 scale on-road
          Pinion Gear: 61 pitch, number of teeth dependent on selected motor
          Body: 1/12 scale high downforce type
          Building and track equipment

SPECS:    Length: 10.4" (265mm)
          Width:   6.7" (170mm)
          Wheelbase: 7.7" (196mm)
          Weight: 29.3oz (830g)
          Internal Gear Ratio: 1:1

COMMENTS: For Replacement Ball Bearings use:
            Qty.    Size        Location               Qty   Bearing Set
             2     1/4x3x8"     Rear Axle               2     ASCC7600
             2     1/4x3x8"     Ride Height Adjuster    2     ASCC7600
             8     1/8x5/16"    Fr & Rear Wheels        4     ASCC4125

                                                                    jxs 3/14/08
                                                                         ir/jxs



– If you need more information, use these Associated resources –

Web Site: http://www.rc10.com/
Phone: 949-544-7500


 
Postal Address:
Associated
26021 COMMERCENTRE DR
LAKE FOREST, CA 92630  








Click here for Units of Measure Conversion Calculators