View Larger Picture

E-mail This Page To A Friend

            This is the radio controlled glow powered, ready to run
           Hot Bodies Lightning Pro 2 Off Road Buggy with Red Body.

FEATURES: Chassis: Aluminum 0.12" (3mm) thick (purple anodized)
          Drive: Four wheel, shaft driven
          Radio: HPI TF-1 27MHz AM with high torque steering servo, steering
            and throttle trim and reverse, dual rate steering, transmitter does
            not have charge jack
          Engine: HPI .28 cu in (4.6cc) Power House big block engine with
            electric starter
          Exhaust: Tuned pipe with header
          Fuel Tank: Plastic with flip top cap, splash guard and overflow drain
            5.1 oz (150cc)
          Clutch: Three shoe, 13 tooth metal clutch bell and purple aluminum
            flywheel
          Transmission: Single-speed
          Ball Bearings: Rubber sealed, used throughout except servo saver
            where bushings are used
          Shocks: Four aluminum bodied, oil filled with coil-over springs,
            plastic shock spacers, and 3.5mm hardened shock shafts
          7075 (T6) 4mm thick front and rear shock towers (purple anodized)
          Main Gear: Metal, 46 tooth
          Gearbox: Sealed front and rear
          Differentials: Bevel gear (hardened)
          Brake: Dual disk on the front and single disk on the rear
          Tires: 1.6" (41mm) wide, 3" (76mm) inner diameter, 4.75" (121mm)
            outer diameter knobby tread rubber with foam inserts pre-glued to
            wheels
          Wheels: White dish plastic 1.6" (41mm) wide, 3" (76mm) diameter
          Body: Painted polycarbonate plastic buggy with nylon rear racing wing
          Bumpers: Black plastic partial front bumper
          Suspension: Front and rear sway bars
          Caster: Adjustable, caster/toe-in refers to the angle of the front
            suspension when viewed from the side of the car in relation to the
            chassis
          Camber: Adjustable front and rear, camber refers to the angle of
            the tops of the tires from vertical when when viewed from front or
            behind vehicle
          Steering: Bell-crank type with two steering link mounts for
            Ackerman adjustability, Ackerman refers to the inside wheel turning
            faster that the outside wheel during turns
          Servo Saver: Included
          22 degree hub carriers
          Front CVA axles and rear dog bones
          Center CVA shafts (front and rear)
          Machined aluminum front and rear braces (purple anodized)
          Front and rear sway bars

INCLUDES: One Hot Bodies Lightning 1/8 scale RTR buggy with oil-filled
           aluminum bodied shocks, painted body with wing, air filter, 46 tooth
           tooth main gear, tuned pipe, manifold with spring, fuel tubing,
           engine, radio system, setup DVD, decal sheet, 4 way wrench, 13 tooth
           clutch bell, and illustrated instruction manual

REQUIRES: Starter Battery: 7.2V stick 6-cell with Tamiya type connector
          AA Batteries: 12AA
          Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant.
            Most of the fuels we carry meet or exceed the lubricant content
            required for optimum performance and maximum engine life. In the
            past, the conventional lubricant content used in fuel was 18%. But
            with new advanced technologies, fuels like Red Alert and O'Donnell
            for example, have a better quality of lubricants even though the
            percentages of lubricant content are lower. These high-tech
            lubricants provide exceptional cooling and protection.
          Glow starter, fuel bottle and track equipment

SPECS:      Vehicle-
          Length:          22.9"  (582mm)
          Width:           16.4"  (416mm)
          Height:           6.25" (159mm)
          Weight:         7.2 lbs (3275g) approx
          Wheelbase: 14.5" (369mm) wheels on-center front-to-rear
          Front and Rear Tread: 14" (356mm)
          Front and Rear Track: 16.1" (410mm)
          Ground Clearance:  2"   (51mm)
          Gear Ratio: 3.6 :1
            Body-
          Length:  18.1" (460mm)
          Width:    7.1" (181mm)
          Height:   5.1" (130mm)

COMMENTS: For replacement ball bearings use:
            Qty.  Size      Location                 Qty.  Bearing Set
             8  8x16x5mm   Fr & Rear Wheel Hubs       4     HPIC2085
             6  8x16x5mm   Fr, Rear & Center Diffs    3     HPIC2085
             2  5x10mm     Clutch                     1     DTXC1535

                                                                    jxs 5/12/08
                                                                         ir/jxs



– If you need more information, use these Hot Bodies resources –

E-mail: support@hpiracing.com
Web Site: http://www.hotbodiesonline.net/
Phone: 949-753-1099


 
Postal Address:
Hot Bodies
70 ICON RANCH
FOOTHILL RANCH, CA 92610  








Click here for Units of Measure Conversion Calculators