View Larger Picture

E-mail This Page To A Friend

    This is the RB Concept C6 BBTII L2G .21 cu in (3.49cc) Off-Road Engine
                        Pipe and Header Combo
                Designed for high competition off-road races.

FEATURES:   ENGINE-
          Newly developed L2G 11-fin orange colored aluminum cooling head
            lowers weight to improve vehicle's handling and increases cooling
            efficiency with fins concentrated around combustion chamber
          Vacuum molded alloy crankcase
          5+2 bypass intake liner, three exhaust ports, ABC construction,
            "A"luminum piston with a "B"rass cylinder liner that is "C"hrome
            plated
          Nylon body slide valve carburetor with 9mm venturi
          14mm crankshaft
          Aircraft grade alloy connecting rod

            PIPE/HEADER-
          Polished chrome aluminum construction
          Designed for 1/8 scale buggy or truggy
          Designed for the perfect balance of smooth power,high RPM and
            low fuel consumption
          Three chamber design
          Factory installed pressure nipple

INCLUDES: RB Concept C6 BBT L2GII Off-Road Engine with turbo glow plug, slide
            valve carburetor, pipe, header, exhaust gasket and instructions

REQUIRES: Fuel: Car blend with 10%-25% nitro content
          Glow plug wrench and track equipment

SPECS:    Displacement: 0.21cu in (3.48cc)
          Bore: 16.22mm
          Stroke: 16.80mm
          Intake Ports: 5+2 bypass
          Exhaust Ports: 3
          Crankshaft: 14mm
          Carburetor Intake Diameter: 9mm
          Carburetor Settings: Main Needle, 3.5 turns from closed
                               Idle Needle, 5 turns from closed
          Weight: 13oz (370g)

          Distance from Backplate to end of Crankshaft: 3.7" (94mm)
          Height from Crankcase Bottom to top of Cylinder Head: 4" (102mm)
          Height from Mounting Tab to top of Cylinder Head: 3.7" (86mm)
          Center of Mounting Holes Same Side: 0.83"  (21mm)
          Center of Mounting Holes Opposite Side: 1.5" (37.5mm)
          Mounting Hole Diameter: 0.12" (3.2mm)
          Distance from Front Bearing to End of Crankshaft: 1.2" (29.5mm)
          Width of Crankcase Below Mounting Tabs: 1.3" (32.5mm)
          Width at Mounting Tabs: 1.8" (45mm)
          Distance/Bottom of Crankcase to Crankshaft Center: 0.61" (15.5mm)
          Distance/Exhaust Port Center to Crankshaft Center: 1.2" (30mm)
          Diameter of Cooling Head: 2.4" (60mm)

COMMENTS: Engine (RBDG0081) and Tuned Pipe (RBDG1240) are available separately.

                                                                    jml 6/23/08
                                                                         ir/jxs



– If you need more information, use these RB Products resources –

E-mail: b.howard@rb-usa.com
Web Site: http://www.rb-usa.com/
Phone: 817-876-9707


 
Postal Address:
RB Products
5611 COLLEYVILLE BLVD #160
COLLEYVILLE, TX 76034  








Click here for Units of Measure Conversion Calculators