This is a Macs Products Tuned Pipe Adapter (Exhaust Manifold or Header).
FEATURES: Used to Adapt a Tuned Pipe to a Side Exhaust Engine.
Made of Metal Tubing That Turns 90 Degrees Outward and Towards the
Rear of the Engine.
At the Output End of this Adaptor the Silicone Coupler Slides On and
is Secured by One Tie-Wrap (Included).
The Tuned Pipe (Not Included), Then Fits Into the Silicone Tubing and
is Secured by One Tie-Wrap (Included).
The Pipe is "Tuned" by Shortening or Lengthening the Distance of the
Tuned Pipe Where It Fits Into the Silicone Coupler Until the
Engine Reaches Maximum Power and RPMs.
If Maximum RPMs Cannot be Reached Within the Silicone Tubing,
Cut Off Output End of Adapter in 1/4" Segments Until No Further
Increase or a Drop in Speed is Noted.
INCLUDES: .120AX Standard Tuned Pipe Adapter
Gray Silicone Coupler
Two White Nylon Tie-Wraps
Two Mounting Screws 1-15/16" (43mm) (Original Screw Is 4 x 40mm)
Two Lock Washers
SPECS: Overall Length: 9-1/4" (235mm)
Inner Diameter: 3/4" (19.2mm)
Outer Diameter: 7/8" (22.28mm)
Mounting Screws Center-to-Center: 1.94" (49.28mm)
Port: 10mm x 36mm rectangular
COMMENTS: For the standard tuned pipe adapter, (MACG2990)
For the extra long tuned pipe adapter (MACG2992)
cnh 6/11/08
ir/jxs
– If you need more information, use these Macs resources – |
Web Site: http://www.macspro.com/
Phone: 916-456-6932
|
|
Postal Address:
Macs
7935-A CARLTON ROAD
SACRAMENTO, CA 95826
|
Click here for Units of Measure Conversion Calculators
Yes
E-mail This Page To A Friend
