View Larger Picture

Tower Catalog Page:	59
E-mail This Page To A Friend

           This is the radio controlled, glider or electric powered
            Multiplex Easy Glider Pro almost ready to fly Sailplane.

FEATURES: Construction: Elapor foam to resist damage, white in color
          Wings: Two piece with fiberglass wing joiner
          Spinner: Elapor foam 2.2" (55mm) diameter
          Aileron Control: Dual servo
          Control Surfaces: Elevator, rudder and ailerons

INCLUDES: One Multiplex Easy Glider Pro with decal sheet, foam spinner, wing
            joiner, pushrods, hardware and illustrated instruction manual

REQUIRES: Radio System: 4-channel with micro receiver
          Servos: Two micro size for elevator & rudder
                  Two nano size for ailerons
          Servo Extensions: Two 16" (200mm) for aileron servos
          Y Harness: For aileron servos
          Battery: at least 2100mAh
          Battery Charger: LiPo compatible
          If building as glider only the following items are required;
            NiMH Receiver Battery (at least 1800mAh)
            Switch Harness with Charge Jack
            Launching Kit
          If installing electric power the following items are required;
            Easy Gilder Pro Power Set #33 2636 or upgraded Power Set #33 2642
            Propeller Driver and Spinner #73 3500 (MPUG3226)
          Building and Field Equipment: Medium viscosity regular (NOT styrofoam
            safe) CA glue and activator, see COMMENTS

SPECS:    Wingspan: 71" (180.3cm)
          Length: 43.7" (112.3cm)
          Flying Weight: 28.5oz (810g) with standard power system
          Wing Loading: 6.5 oz sq ft (20 g sq/dm) with standard power system
          Wing Area: FAI approx. 226 sq in (41.6g/sq dm)
          Airfoil: Semi symmetrical
          CG (Center of Gravity): 2.7" (70mm) from leading edge at wing root
            measured at fuselage side
            Control Throws-
          Elevator, Up and Down:     0.31-0.39" (8-10mm)
          Rudder, Left and Right:    0.59-0.79" (15-20mm)
          Ailerons, Up:              0.59" (15mm)
                    Down:            0.24" (6mm)
          Spoilers-Both Ailerons Up: 0.79" (20mm)
          Spoiler Mixer (Elevator Trim Compensation): 0.16" (4mm)

COMMENTS: This model is NOT made of styrofoam and it is not possible to glue
            the material using white or epoxy glue. Medium CA glue used with an
            activator is the only method of gluing recommended by the
            manufacturer.

          Also available with preinstalled servos and leads, MPUA2626.

                                                                    jxs 7/21/08
                                                                         ir/jxs



– If you need more information, use these Multiplex resources –

Web Site: http://www.multiplexusa.com/
Phone: 858-748-6948


 
Postal Address:
Multiplex
12115 PAINE STREET
POWAY, CA 92064  








Click here for Units of Measure Conversion Calculators