View Larger Picture

Parts Express Eligible:	Yes
E-mail This Page To A Friend

           This is the Fuel Inlet for the Tower 61 and 75 Engines.
            The inlet is located on the remote needle valve where
          fuel comes from the tank and then goes to the carburetor.

FEATURES: Pre-assembled fuel inlet
          Threaded end for assembly onto the remote needle

INCLUDES: One fuel inlet
          Two pressure fittings (nipples) (TOWG4994)
          Two small Red fiber washers
          One large Red fiber washer
          One 63mm silicone fuel tubing

REQUIRES: Assembly onto the remote needle valve
          5mm nut driver to tighten pressure fittings

SPECS:    Length:          16mm
          Outer diameter: 9.8mm

COMMENTS: Pressure fittings are mounted at a right angle to each other.
                                                                     cmc 1/9/01
                                                                          ir/jl




– If you need more information, use these Tower Hobbies resources –

E-mail: info@towerhobbies.com
Web Site: http://www.towerhobbies.com/
Phone: 217-398-8970


 
Postal Address:
Tower Hobbies
PO BOX 9078
CHAMPAIGN, IL 61826  








Click here for Units of Measure Conversion Calculators