Parts Express Eligible:	Yes
E-mail This Page To A Friend

      This is the Hi-Speed Needle Valve for the Tower 61 and 75 Engines.
              This is located on the remote needle assembly and
                    adjusts fuel flow to the carburetor.

FEATURES: Knurled needle top for adjustment by fingers
          O-rings are pre-installed

INCLUDES: One Hi-Speed Needle
          Two Black O-rings (pre-installed)

REQUIRES: Assembly onto the needle valve assembly

SPECS:    Length: 34.5mm
          Knurled portion length:    10mm
          Knurled portion diameter: 6.9mm
          Hole diameter at the end of needle: 1.7mm

COMMENTS: This needle simply threads into the Hi-Speed Needle valve assembly
           There is also a set screw pre-installed into the knurled part of the
             needle, and a hole at the end of the needle so a piece of wire
             or hex wrench can be used as a needle valve extension.  The set
             screw requires a 1.5mm hex wrench to tighten it.
                                                                     cmc 1/9/01
                                                                          ir/jl



– If you need more information, use these Tower Hobbies resources –

E-mail: info@towerhobbies.com
Web Site: http://www.towerhobbies.com/
Phone: 217-398-8970


 
Postal Address:
Tower Hobbies
PO BOX 9078
CHAMPAIGN, IL 61826  








Click here for Units of Measure Conversion Calculators