Parts Express Eligible:	Yes
E-mail This Page To A Friend

        This is the Astro Model 105 Servo Tester from Astro Flight Inc.

FEATURES: Plastic case
          Aluminum face plate
          Universal connectors

INCLUDES: One servo tester
          One instruction sheet

REQUIRES: A servo or motor to test

SPECS:    Length:   2-5/8"    Leads: 5-1/4" including connectors
          Width:    1-5/8"
          Height:   5/8" (case) 1-1/4" including dial

COMMENTS: With this you can do the following without using your radio:
           - Run electric motors
           - Test servos
           - Know at what receiver pulse width your motor starts
           - Know at what receiver pulse width your motor is fully on
           - Match your transmitter throttle channel to your speed control

          This Servo Tester can be used with or without an external receiver
           nicad battery pack. You will find two radio cables on the tester.
           The three wire cable goes to your servo or Electronic Speed
           Control. If your speed control has a BEC circuit, it will not be
           necessary to use a separate 4 cell receiver battery. If your
           speed control has no BEC circuit or if your are testing servos,
           you will need to use the receiver battery. Connect the receiver
           battery to the two wire radio connector.

          The Model 105 Servo Tester operating mode allows user to adjust servo
            signal from one millisecond (low throttle) to two milliseconds
            (high-throttle).
                                                                     tjt 041502
                                                                         ir/kh



– If you need more information, use these Astro Flight resources –

E-mail: info@astroflight.com
Web Site: http://www.astroflight.com/
Phone: 310-821-6242


 
Postal Address:
Astro Flight
13311 BEACH AVENUE
MARINA DEL RAY, CA 90292  








Click here for Units of Measure Conversion Calculators