View Larger Picture

E-mail This Page To A Friend

     This is the 1/8 scale glow powered, radio controlled, ready-to-run
                    Robitronic Mantis TXS Off-Road Truggy.

FEATURES: Chassis: Aluminum 0.12" (3mm) thick anodized red in color, with
            front and rear composite braces
          Drive: Four wheel shaft drive
          Engine: Axial .28 cu in (4.6cc) Spec 1s with pull starter, SG (pilot)
            crankshaft glow plug, slide valve carburetor, two stage foam air
            filter, fuel filter
          Exhaust: Aluminum tuned pipe w/header, black in color
          Fuel Tank: 5.1oz  (150cc) with flip top cap
          Radio: 2-channel 27MHz AM with dual rate steering, steering and
            throttle trim and reverse,  high torque laydown steering servo,
            charging jack on transmitter
          Clutch: 3-shoe, 13 steel tooth clutch bell
          Transmission: Single-speed
          Ball Bearings: Full set, rubber sealed
          Shocks: Four oil-filled, with coil-over spring, hard anodized
            aluminum bodied 3.5mm shafts and 14mm pistons, aluminum 0.16" (4mm)
            thick shock towers
          Main Gear: 52 tooth
          Gearboxes: Sealed
          Differentials: Bevel gear, floating front and rear diffs, ultra low
            design for lower center of gravity
          Brakes: Dual disk
          Tires: Axial Terra-izer block pattern tread, width 2.9" (75mm),
            outside diameter 5.8" (147mm), inside diameter 3.1" (80mm)
          Wheels: Black dish style 2.2" (56mm) wide, 3.5" (88mm) diameter, 17mm
            hex
          Body: Painted and trimmed Axial Mantis truggy style with molded
            composite wing, color scheme is white and red with gray and black
            trim
          Bumpers: Front and rear composite, black in color
          Suspension: Adjustable, with rubber dampened hinge pin pivot points
            front and rear anti-sway bars
          Caster: Adjustable, caster/toe-in refers to the angle of the front
            suspension when viewed from the side of the car in relation to the
            chassis
          Camber: Adjustable, camber refers to the angle of the tops of the
            tires from vertical when viewed from front or behind vehicle
          Steering: Bushing supported bell-crank with servo saver
          Warranty Period: Two year limited

INCLUDES: 1/8 scale Robitronic Mantis TXS Truggy, Axial .28 Spec 1s engine
            glow plug, painted body, tires, foam inserts, wheels, 13 tooth
            clutch bell, 52 tooth spur gear, instructions, decal sheet, 17oz
            (500cc) fueler bottle, C-size glow starter, 2-ch pistol grip radio
            with high torque steering servo, wrench, fuel filter, wall charger,
            two extra clutch bells, extra shock spacers and servo arms

REQUIRES: 12 AA Batteries: 8 for transmitter, 4 for receiver
          C-size Battery: For glow starter
          Misc. Items: Tools and building equipment
          Fuel: 2-cycle glow fuel with 20%-30% nitromethane, 16% lubricant-
            Most of the fuels we carry meet or exceed the lubricant content
            required for optimum performance and maximum engine life.  In the
            past, the conventional lubricant content used in fuel was 18%.  But
            with new advanced technologies, fuels like Red Alert and O'Donnell
            for example, have a better quality of lubricants even though the
            percentages of lubricant content are lower.  These high-tech
            lubricants provide exceptional cooling and protection.

SPECS:      Vehicle-
          Length:          21.6"  (550mm)
          Width:           16.3"  (415mm)
          Height:           7.5"  (190mm)
          Weight:           8.7 lbs (3935g) approx.
          Wheelbase:       14.2 - 14.5" (362 - 368mm) adjustable
          Front Tread:     13.4"  (341mm)
          Rear Tread:      14.2"  (360mm) wheels on-center side-to-side
          Front Track:     16"    (406mm)
          Rear Track:      16.7"  (425mm) outer edges of wheels
          Ground Clearance: 1.6"   (42mm)
          Tires: Width 2.9" (75mm), Outside Diameter 5.8" (147mm), Inside
            Diameter 3.1" (80mm)
            Body-
          Length:  17"   (432mm)
          Width:    8.2" (208mm) in front of rear wheels (widest point)
                    6.1" (155mm) in front of front wheels (thinnest point)
          Height:   4.2" (106mm)

COMMENTS: For Replacement Ball Bearings use:
            Qty.  Size      Location                   Qty.  Bearing Set
             2   8x16mm     Fr Diff                     1    DTXC1585
             2   8x16mm     Rear Diff                   1    DTXC1585
             2   8x16mm     Center Diff                 1    DTXC1585
             2   8x16mm     Front Gearbox               1    DTXC1585
             4   8x16mm     Front Hubs                  2    DTXC1585
             2   8x16mm     Rear Gearbox                1    DTXC1585
             4   8x16mm     Rear Hubs                   2    DTXC1585
             2   5x10mm     Clutch Bell                 1    DTXC1535

          It is not possible to request a specific radio channel when ordering
             because they are supplied by the manufacturer at random.

                                                                   jxs 12/23/08
                                                                         ir/jxs



– If you need more information, use these Robitronic resources –

Web Site: http://www.skmotion.com
Phone: 949-705-6668


 
Postal Address:
Robitronic
C/O SK MOTION
385 S LEMON AVE #E 238
WALNUT, CA 91789  








Click here for Units of Measure Conversion Calculators