View Larger Picture

Tower Catalog Page:	115
E-mail This Page To A Friend

      This is the radio controlled, glow powered, 1/8 scale ready to run
                     Ofna Mutilator Power Start Truggy.

FEATURES: Chassis: 0.12" (3mm) thick aluminum hard anodized
          Engine Starter: Electric shaft type
          Engine: Ofna .28 cu in (4.6cc) slide
            valve carburetor, heavy duty foam air filter and glow plug
          Exhaust: Polished aluminum dual chambered tuned pipe and header
          Radio: Ofna 2-channel AM transmitter and reciever
           with SX-002 high torque servo and SX-001 standard servo
          Radio Box: Low profile nylon fully enclosed box
          Ball Bearings: Full set
          Shocks: Four aluminum threaded Big Bore oil filled shocks w/blue
            springs 0.16" (4mm) thick aluminum shock towers
          Fuel Tank: 4.9oz (145cc) flip top siphon type Ttnk
          Clutch: 3-shoe, constructed of nylon
          Transmission: Single speed
          Main Gear: 62T steel spur gear
          Differentials: Three, sealed with anodized aluminum center diff plate
          Brake: Two fiberglass brake disks
          Tires: LPR Bow-Tie
                  Width: 67.25mm (2.6")
                  Diameter: 148mm (5.8")
                  Hex: 17mm
          Wheels: LPR White dish type w/17mm hex adapters
          Body: Pre-painted truggy body with heavy duty nylon racing wing
          Caster: Front and rear adjustable, caster/toe-in refers to the angle
            of the front suspension when viewed from the side of the car in
            relation to the chassis
          Camber: Front and rear adjustable, camber refers to the angle of the
            tops of the tires from vertical when viewed from front or behind
            vehicle
          Suspension: C-Hub

INCLUDES: Ofna Mutilator Power Start Truggy, .28 size engine w/electric power
            starter, pre-installed radio system w/high torque steering servo,
            pre-painted body, pre-mounted tires on white dish wheels, aluminum
            threaded shocks, instruction manual and decals, glow starter and
            fuel bottle

REQUIRES: Radio Batteries: 12 AA size, 8 for transmitter and four for receiver
          D size battery for the included glow starter
          Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant

SPECS:      Chassis-
          Length: 21.5"  (546mm)
          Width:  15.25" (413mm)
          Height:  7"    (178mm)
          Weight: 9.25lbs (4195g)
          Wheelbase: 14.5" (368mm)
          Track:  13.5"  (343mm)
            Body-
          Length: 19.5"  (495mm)
          Width:   7.5"  (190mm)
          Height:  5.5"  (140mm)

COMMENTS: For Replacement Ball Bearings use:
            Qty.  Size      Location                      Qty.  Bearing Set
             6   8x16mm    Front, Rear & Center Diffs      3     DTXC1585
             4   8x16mm    Front and Rear gear boxes       3     DTXC1585
             4   8x16mm    Front Knuckles                  2     DTXC1585
             4   8x16mm    Rear Hubs                       2     DTXC1585
             2   5x10mm    Clutch Bell                     1     DTXC1535

          Carburetor Needle Settings;
            Master Needle Valve, 3-3-1/2 turns from closed
            Low Speed Needle, Flush with ball end
            Barrel Stop Screws (used to adjust idle) 1/16" gap

          It is not possible to request a specific radio channel when ordering
            because they are supplied by the manufacturer at random.

                                                                   jxs 12/12/08
                                                                         ir/jxs



– If you need more information, use these Ofna resources –

E-mail: help@ofna.com
Web Site: http://www.ofna.com/
Phone: 949-586-2910


 
Postal Address:
Ofna
7 VANDERBILT
IRVINE, CA 92618  








Click here for Units of Measure Conversion Calculators