Parts Express Eligible:	Yes
E-mail This Page To A Friend

   This is the Muffler Assembly for the Tower Hobbies .15 Pull-Start Engine.
      This muffler attaches to the crankcase to reduce noise and provides
                   back pressure for low speed performance.

FEATURES: Replaces entire muffler
          Constructed of lightweight aluminum
          Pressure tap pre-installed (3mm threads)
          Rear section of muffler is rotatable to direct exhaust up or down

INCLUDES: One Muffler Assembly for the Tower Hobbies .15 Pull-Start Engine with
            Front section: TOWG4706
            Rear section:  TOWG4708
            2.6 x 60mm muffler assembly screw and nut: TOWG4709

REQUIRES: Attaching to engine using Muffler Mounting Screws (TOWG4835)
          Installing gasket (TOWG4645) between muffler and crankcase
          5mm wrench to tighten pressure fitting

SPECS:    Length:  2.16"   (55mm)
          Diameter: .82" (20.7mm)
          Distance between mounting holes on-center: 1.13" (28.8mm)
                                                                    JXS 5/14/01
                                                                          ir/jl




– If you need more information, use these Tower Hobbies resources –

E-mail: info@towerhobbies.com
Web Site: http://www.towerhobbies.com/
Phone: 217-398-8970


 
Postal Address:
Tower Hobbies
PO BOX 9078
CHAMPAIGN, IL 61826  








Click here for Units of Measure Conversion Calculators