View Larger Picture

Parts Express Eligible:	Yes
E-mail This Page To A Friend

             This is the Carburetor Body for the #40E Carburetor.
             This is used on the O.S. Max .50SX-H and HG Engines.

FEATURES: Aluminum construction

INCLUDES: One Carburetor Body

SPECS:    Outer Diameter of Carb Base: 11.4mm
          Height: 38mm
          Width:  37mm

COMMENTS: This is the Carb Body ONLY.  It does not include the rotor, throttle
            lever, needle valves, mounting screws, and so on.

    There is only one O-ring for the carb body. The O-ring for this is
      different than the one for the .46-FZ. The proper part number is
      OSMG6228, as this O-ring is slightly larger in diameter and a
      little thinner.
   The best way to insert the carb assembly is to place the brass insert
     about half way into the case, put the O-ring around the brass
     insert and press the careb down tight against the case. There will
     be a gap between the base of the carb, and the case, but the gap
     will be very small. You should only be able to see the black O-ring

                                                                    dew 3/26/01
                                                                          ir/jl



– If you need more information, use these O.S. resources –

E-mail: enginesupport@hobbico.com
Web Site: http://www.osengines.com/
Phone: 217-398-8970


 
Postal Address:
O.S.
3002 N. APOLLO DRIVE, SUITE #1
CHAMPAIGN, IL 61822  








Click here for Units of Measure Conversion Calculators