View Larger Picture

E-mail This Page To A Friend

              This is the Axial .32RR Spec 1 Engine from Axial.
                with Pull Starter and SG (pilot) Crankshaft.
   Based on the Axial .28RR this engine is designed to be more efficient and
           powerful than the previous .32 engine making it ideal
                          for monster truck bashing.

FEATURES: ABC cylinder and liner construction- "A"luminum piston, "B"rass
            cylinder liner that is "C"hrome plated
          Composite bodied 9.0mm 3-needle slide valve carburetor, factory reset
            line on High-Speed Needle and flush needles make resetting to
            factory specs easy, also includes 8.0 and 8.5mm venturis
          Balanced crankshaft for improved RPM and efficiency
          Six-port cylinder sleeve
          Dual bushing aluminum connecting rod

INCLUDES: Axial .32RR Spec 1 Engine in Black with pull starter, carburetor,
            8.5 and 8.0mm venturis, instruction Sheet

REQUIRES: Glow Plug: Cold heat range
          Fuel: 20-30% Nitro with at least 18% oil content
          Manifold and Tuned Pipe: Depends on vehicle

SPECS:    Displacement: .32 cu in (5.2cc)
          Maximum RPM: 37,500
          Bore: 19.5mm
          Stroke: 17.5mm
          Distance Between Mounting Holes Same Side: 22mm (0.87")
          Distance Between Mounting Holes Opposite Side: 37.03mm (1.45")
          Height Bottom of Mounting Tabs/Top of Cylinder Head: 100.4mm (3.9")
          Width at Mounting Tabs: 45mm (1.8")
          Distance from Pull Starter to Front Bearing: 83.22mm (3.276")
          Distance from Center of Engine to Front Bearing: 41.61mm (1.63")
          Distance from Center of Engine to Pull Starter:  41.61mm (1.63")
          Carburetor Settings: Factory set for proper break-in-reset only after
             engine is fully broken in
            High Speed Needle-Turn in 1/8 turn increments to lean out fuel
             mixture to a maximum 2-1/2 turns from flush
            Idle Adjustment Screw-Turn on radio and set throttle trim to
             neutral, turn idle adjustment screw to set idle high enough to
             keep engine running but not high enough to engage clutch
            Low Speed Needle-Leave at factory setting, no adjustment needed

                                                                    jxs 9/09/09
                                                                         ir/jxs



– If you need more information, use these Axial resources –

E-mail: service@axialracing.com
Web Site: http://www.axialracing.com/
Phone: 949-600-8642


 
Postal Address:
Axial
8 GOODYEAR, SUITE 125
IRVINE, CA 92618  








Click here for Units of Measure Conversion Calculators