This is the Havoc Pro Brushless Electronic Speed Control from Novak.
FEATURES: Compatible with all Novak 540-size brushless motors and any ROAR-
approved 540-sized sensored motor down to 3.5 turns
Nine adjustable parameters: Minimum Brake, Drag Brake, Dead Band,
Minimum Drive, Curve, Brake Frequency, Reverse Motor
Rotation and Battery Pack Selection (Li-Po, Li-Fe, Ni-MH)
Fifty percent more transistors than the Havoc 2S ESC for faster
speeds, higher efficiency and increased load handling
Locked rotor detection and thermal overload protection (when used
with a Novak sensored brushless motor)
Clear cooling fan (NOVC5648) mounted on factory-installed heat sink
One-touch set-up for quick, easy transmitter setup
Radio-priority and polar drive circuits
120 day limited warranty through manufacturer
INCLUDES: Novak Havoc Pro ESC, cooling fan, shrink wrap, instruction sheet and
zip ties
REQUIRES: Compatible 540 size brushless motor
SPECS: Input Voltage: 2S Li-Po cells, 2S Li-Fe cells or 4-6 cells
(1.2V/cell)
Size: 1.16 x 1.49" (29.5 x 37.8mm)
Weight (without wires): 1.36oz. (38.5g)
Design: Sensor-based
Motor Limit (brushless): All 3.5-turn Novak 540-size sensored
brushless motors
On-Resistance (brushless): 0.00040 ohms @ 25°C trans. temp.
BEC: 6.0 volts DC / 3.0 amps
Rated Current: 540 Amps @ 25°C trans. temp.
Braking Current: 540 Amps @ 25°C trans. temp.
Status LEDs: 4
Voltage Cut-Off: 6.25V (Li-Po), 4.75V (Li-Fe)
Power Wires: 14G super-flex copper-strand silicone wire
jxs 10/08/09
ir/jxs
– If you need more information, use these Novak resources – |
E-mail: cs@teamnovak.com
Phone: 949-833-8873
|
|
Postal Address:
Novak
17032 ARMSTRONG AVENUE
IRVINE, CA 92614
|
Click here for Units of Measure Conversion Calculators
|