This is the electric powered, radio controlled,
Associated Factory Team 12R5.1 1/12 scale On-Road Pan Car Kit.
FEATURES: Chassis: 0.10" (2.5mm) thick woven carbon fiber with top plate,
wide rear pod for easy installation of brushless motors and better
heat dissipation, Factory Team pivot ball-link chassis allows for
independent roll, bump and alignment adjustment
Drive: Two wheel rear
Ball Bearings: Full set included
Differential: Ball type
Motor Mount: Factory Team blue machined aluminum
Shock: Factory Team shock with through-shaft design
for equalized damping throughout the full stroke with no unwanted
rebound, shock also controls chassis droop and adjusts with a
turnbuckle wrench, woven carbon fiber center shock tower with four
mounting positions
Suspension: Pivot ball link rear suspension allowing independent
adjustments for chassis roll, bump and alignment, active strut
front end with symmetric components and adjustable caster and
track width
Bumper: Foam front
Caster: Adjustable, caster/toe-in refers to the angle of the front
suspension when viewed from the side of the car in relation to the
chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle
Ackerman: Adjustable with spacers, Ackerman describes the effect of
the inside front wheel turning faster than the outside front wheel
during turns
INCLUDES: Associated Factory Team 12R5.1 Pan Car Kit with decals, 96T spur gear
illustrated instruction manual
REQUIRES: Radio: 2-channel with mini steering servo
Electronic Speed Control: For stock or modified motor
Motor: 540 size
Battery: 4-cell sub-C 2x2 flat configuration
Battery Charger: Peak type for selected battery
Wheels and Tires: 1/12 scale on-road
Pinion Gear: 61 pitch, number of teeth dependent on selected motor
Body: 1/12 scale high downforce type
Building and track equipment
SPECS: Length: 10.4" (265mm)
Width: 6.7" (170mm)
Wheelbase: 7.7" (196mm)
Weight: 29.3oz (830g)
Internal Gear Ratio: 1:1
COMMENTS: For Replacement Ball Bearings use:
Qty. Size Location Qty Bearing Set
2 1/4x3x8" Rear Axle 2 ASCC7600
2 1/4x3x8" Ride Height Adjuster 2 ASCC7600
8 1/8x5/16" Fr & Rear Wheels 4 ASCC4125
jxs 9/01/09
ir/jxs
– If you need more information, use these Associated resources – |
Web Site: http://www.rc10.com/
Phone: 949-544-7500
|
|
Postal Address:
Associated
26021 COMMERCENTRE DR
LAKE FOREST, CA 92630
|
Click here for Units of Measure Conversion Calculators
| 
E-mail This Page To A Friend
Primary Accessories
Primary Accessories
