This is the 1/10 scale Associated Electric Powered, Radio Controlled,
                  RC10TC6.1 Factory Team Worlds Car Kit.

                **Body Shown In Picture Is Not Included.**

FEATURES: Chassis: Ultra narrow 0.088" (2.25mm) thick carbon fiber with
            optimized flex and maximum chassis roll ground clearance
          Drive: Four wheel belt drive
          Shocks: Factory Team VCS3 with hard anodized aluminum threaded bodies
            with bottom loaded seals
          Shock Towers: Carbon fiber
          Suspension: Front and rear anti-roll bars with the H.D.R.C. (High
            Definition Roll Control) system, roll stiffness is controlled and
            adjusted by two wires mounted into an aluminum center member and
            linked to the suspension arms, center member rolls on a bearing
            surface to reduce friction and provide ultra precise movement
          Ball Bearings: Full set, 16 total
          Steering: Multi-position system allows fine tuning of Ackermann
            steering rates, Ackermann refers to the effect of the inner front
            wheel rotating faster than the outer front wheel during turns
          Caster: Adjustable, caster/toe-in refers to the angle of the front
            suspension when viewed from the side of the car in relation to the
            chassis, caster blocks adjust 14, 16, or 18 degrees with molded
            inserts
          Camber: Adjustable, camber refers to the angle of the tops of the
            tires from vertical when viewed from front or behind vehicle
          Spur Gear: Nylon construction, 87 tooth 48 pitch
          Bumper: Front foam

INCLUDES: RC10TC6.1 Factory Team Worlds Car Kit with Shocks, Instruction
            Manual, Decals, Spur Gear,

REQUIRES: Radio: 2-channel with high-speed steering servo
          Motor: For 1/10 scale on-road operation
          Electronic Speed Control: Compatible with selected motor
          Battery: 7.4V LiPo or 6.0V LiFe
          Battery Charger Compatible with selected battery
          Body: 190mm touring car
          Tires: 1/10 scale rubber or foam touring car tires
          Wheels: 1/10 scale touring car with 12mm hex
          Silicone shock oil and diff fluid of modeler's choice
          Building and track equipment

SPECS:    Length: 15" (381mm)
          Width:   7.5"   (190mm)
          Weight: 2.98lbs (1350g) not including tires, wheels, body or
            electronics
          Wheelbase: 10.05- 10.27" (255.5 - 261mm)
          Internal Gear Ratio: 2.0:1

COMMENTS: For Replacement Ball Bearings use:
            Qty.  Size      Location       Qty.       Stock Number
             2   10x15mm   Front Spool      1           DTXC1595
             2   10x15mm   Rear Diff        1           DTXC1595
             2   4x8mm flanged Spur Gear Shaft  1       DTXC1517
             4   5x10mm    Steering Blocks  2           DTXC1535
             4   5x10mm    Rear Hubs        2           DTXC1535

                                                                   jxs 10/30/12
                                                                         ir/jxs