This is the Radio Controlled, Electric Powered, 1/10 scale
        Factory Team RC10R5.1 On-Road Pan Car Kit from Team Associated.

FEATURES: Chassis: Carbon fiber 0.10" (2.5mm) thick with chassis stiffening
            rails that provide a centralized LiPo battery mounting position
            that fits ROAR-approved 3.7V and 7.4V LiPo batteries, and allows
            front-to-rear weight bias adjustments
          Drive: Rear wheel
          Motor Mount: Aluminum
            with 3-point upper pod plate with graphite motor mount crossbrace
          Rear Differential: Ball type
          Front Suspension: Dynamic Strut design with symmetrical components
           and adjustable caster and track width, updated lower control arms
           for more accurate mounting
          Rear Suspension: Pivot ball rear pod with hard anodized pivot balls
            at each point and separate adjustment of roll and bump, rear
            aluminum bulkheads are tied together with carbon fiber motor mount
            cross brace for greater rigidity
          Shock: Center mount with through-shaft design that provides equal
            damping throughout the full stroke of the shock without unwanted
            rebound
          Front Bumper: Foam
          Spur Gear: Nylon 96 tooth 64 pitch
          Caster: Adjustable, caster/toe-in refers to the angle of the
            suspension when viewed from the side of the car in relation to the
            chassis
          Camber: Adjustable, camber refers to the angle of the tops of the
            tires from vertical when viewed from front or behind vehicle

INCLUDES: RC10R5.1 On-Road Pan Car Kit with Shock Fluid, Decals, Ball Bearings
            and Instruction Manual

REQUIRES: Radio: Two-channel with 1/12 scale servo
          Motor: 540 size, brushless recommended
          Electronic Speed Control: Compatible with selected motor
          Battery: 1S LiPo pack
          Battery Charger: Compatible with selected battery
          Pinion Gear: 64 pitch (number of teeth determined by motor and
            battery combination)
          Tires: 1/10 scale foam
          Body: 1/10 scale 190mm pan car racing body
          Building and track equipment

SPECS:    Wheelbase: 10.2" (259mm)

COMMENTS: For Replacement Ball Bearings use:
            Qty.   Size         Location          Qty.    Bearing Set
             3   3/8x1/4"      Differential        2       DTXC1433
             2   3/8x1/4"      Rear Axle           1       DTXC1433
             4   1/8x5/16"     Front Wheels        2       DTXC1403

                                                                   jxs 12/06/12
                                                                         ir/jxs