This is the Receiver Ready, Electric Powered, Radio Controlled,
                         Multiplex Razzor Airplane.
                   Recommended for advanced pilots only.
       Includes Receiver and Servos, requires 6-Channel Transmitter

FEATURES: Construction: Elapor foam with carbon reinforced tail
          Wing: One-piece carbon reinforced
          Aileron Control: Dual servo
          Motor: Brushless Permax BL-0 2316-1400
          Electronic Speed Control: MULTIcont BL 15, see battery charger
            requirements below
          Servos: Four MS-9004
          Receiver: 5-channel 2.4GHz
          Battery: 3S, 800mAh
          Propeller: Plastic, 7x6
          Spinner: Elapor foam 1.3" (34mm) diameter
          Landing Gear: Prebent wire covered with Elapor foam, and foam wheel
            pants, with two 1" (25.4mm) main wheels

INCLUDES: RR Multiplex Razzor Airplane with ESC, Motor, four Servos, Receiver,
            LiPo Battery two Propellers, and Instructions

REQUIRES: Transmitter: At least 3-channel
          Battery Charger: The Duratrax Onyx 235 charger is an ideal choice
            NOTE: If using this charger, the battery connector must be cut off
            and a Deans Ultra Female plug must be soldered to the battery leads
            to match the Deans Male connector supplied with the Onyx charger
            The ESC will also require a Deans Male connector
          Building and Field Equipment

SPECS:    Wingspan: 24.4" (620mm)
          Overall Length: 23.4" (595mm)
          Total Weight: 10.6oz (300g)
          Total Surface Area: 141 sq in (9.1 sq dm)
          Wing Loading: 10.8 oz sq/dm (33 gr/dm)
          Center of Gravity: 1.6" (42mm) from the wing's leading edge at the
            fuselage sides.
          Control Throws-
            Elevator, Up and Down: 0.24" (6mm)
            Rudder, (left and right): 0.98" (25mm)
            Ailerons, Down 0.16" (4mm), Up 0.24" (6mm)

COMMENTS: The only LiPo battery we carry that will fit inside this fuselage is
            the FlightPower Eon-X Lite 350mAh 3S 11.1V 25C (FPWP4015). Deans
            Ultra (WSDM3001) connectors must be soldered to this battery and
            ESC in plane. Run times will be shorter as this battery has a
            lower mAh rating than the original battery supplied with this plane

          This model is NOT made of styrofoam and it is not possible to glue
            Elapor foam using white or epoxy glue. Medium CA glue used with
            an activator is the only method of gluing recommended by the
            manufacturer.

                                                                   jxs 02/28/13
                                                                         ir/jxs