This is a R148DP 8-Ch 72MHz PCM 1024 Dual Conversion Micro Receiver
                             Without Crystal.
 This is a Low Band (channel 11-35) receiver without a crystal (see REQUIRES).

FEATURES: Narrow-band spacing and Dual Conversion signal filtering combine to
            provide exceptionally clear, interference-free reception and
            amazingly smooth, accurate control.

INCLUDES: One R148DP Micro 8 Channel 72MHz PCM 1024 Receiver

REQUIRES: One FUTL57** Dual Conversion Receiver Crystal

SPECS:    Narrow Band: 20KHz
          Intermediate Frequency- 1st IF: 10.7MHz
                                  2nd IF:  455kHz
          Power Requirements: 4.8 to 6.0V (shared with servos)
          Current Drain: 14mA
          Length:   2.19" (55.5mm)
          Width:    1.00" (25.5mm)
          Height:   0.89" (22.5mm)
          Weight: 1.07oz   (30.4g)

COMMENTS: 1024 Resolution is NOT Compatible with Older PCM 512 Systems.
          For the transmitter/receiver crystal set, use FUTL20**.
          For the High Band, use FUTL0823.
          Special Notice about Frequency Changes-
          *72MHz- Low band channels 11 to 35; High band channels 36 to 60.
             Receiver crystal channels (11-35 or 36-60) Within Each Band
             Can Be Changed, and Do Not Require a retuning of the receiver.
          *72MHz Frequency Band (Low or High) for the receiver Can Not Be
             Changed from Low to High band, OR from High to Low band without
             sending it into Futaba Services for retuning.
          *50MHz, 72MHz, 27MHz and 75MHz Frequency Bands Can Not under any
             circumstances be interchanged with each other. 72/75:receiver Must
             be sent in for retuning to the appropriate band. 50/27: can't do.
          *50MHz, 27MHz and 75MHz receiver crystals Can be changed anywhere
             within the respective bands. There are no High or Low bands such
             as the 72MHz band has.
          *Transmitter Crystals Can Not be changed to another channel except
             by a licensed service center. It is against FCC regulations, and
             illegal for the user to change a frequency determining component
             of a transmitter. If the radio is not retuned, it can be a hazard
             spectators, modelers or property, and void AMA insurance coverage.
          *Check with the local R/C club for the frequencies used in your area.

                                                                     kh12-04-01
                                                            updated jpg 7/21/05
                                                            updated jpg 9/23/05