This is the glow powered, radio controlled, almost ready to fly
           Thunder Tiger Raptor 30 V2 Pro Receiver Ready Helicopter.
             For RC Helicopter Pilots 14 Years of Age and Older.

FEATURES: Tail Drive: Belt
          Tail Boom: Aluminum with rigid support with plastic end
          Body: White plastic with tinted canopy
          Main Blades: Wooden, natural finish with clear protective coating
          Tail Rotor Blades: White plastic
          Gyro: TG7000 Heading lock
          Servos: Five, four S1903 standard, one DS0606 digital rudder servo
          Engine: PRO 39H (R) with ringed piston, two needle carburetor,
            Schnuerle porting, glow plug, two ball bearings, aluminum muffler
            with heatsink
          Landing Gear: Nylon with aluminum skids
          Fuel Tank: 11.5oz (340cc)

INCLUDES: Thunder Tiger Raptor 30 V2 Pro Heli kit, PRO 39H (R) Engine, Glow
            Plug, Gyro, Blades, Canopy, Decals and Instruction Manual

REQUIRES: Radio: 6-channel
          Flight Battery: 4.8V NiMH at least 1200mAh
          Glow Fuel: Heli blend 15-30%
          Starting Shaft: 6mm hex size
          Electric Starter: 12V .90 size
          Remote Glow Starter
          Building and field equipment

SPECS:    Fuselage Length: 45.27" (1150mm)
          Fuselage Width: 5.51" (140mm)
          Total Height: 15.75" (400mm)
          Main Rotor Diameter: 49" (1245mm)
          Tail Rotor Diameter: 9.3" (236mm)
          Gear Ratio: 1:9.56:4.57
          Fully Equipped Weight: 6.6lbs (3000g)

COMMENTS: For Replacement Ball Bearings use:
            Qty.    Size          Location                 Qty.   Bearing
             1     8x16mm        Drive Gear                 1    DTXC1585
             1     6x12mm        Clutch Bell                1    DTXC1569
             1     6x15mm        Top Starter Shaft          1    ARZC2611
             1    10x19mm        Upper Main Shaft           1    HMXE7293
             3     4x7mm         Washout Assembly           2    DTXC1507
             2     8x12mm        Elevator Arm Control       1    DTXC1581
             2     4x7mm         Aileron Control Lever      1    DTXC1507
             2     4x8mm         Collective Pitch Collar    1    DTXC1511
             4     4x7mm         Mixing Lever               2    DTXC1507
             2     3x8mm         Flybar Assembly            1    Not Carried
             1     5x11mm        Tail Housing               1    DTXC1547
             4     5x10mm        Tail Rotor Hub             2    DTXC1535
             2     6x10mm        Tail Pitch Slider          1    DTXC1561
             2     4x7mm         Tail Pitch Control Lever   1    DTXC1507

                                                                   jxs 10/01/10
                                                                         ir/jxs