This is the electric powered, radio controlled, 1/10 scale
               TC6.1 Factory Team Touring Car Kit From Associated.

FEATURES: Chassis: Carbon fiber 0.08" (2mm) thick, narrow layout optimized for
            LiPo batteries and brushless motors
          Drive: Four wheel belt drive with adjustable diff heights and belt
            tension
          Differential: Lightweight ball type with hard anodized outdrives for
            low wear and long life, front spool with replaceable composite
            outdrives
          Ball Bearings: Full set, 16 total
          Shocks: Oil-filled Factory Team VCS3 with hard anodized threaded
            bodies, bottom-loaded seals and increased stroke for more up travel
            at the wheels for better overall traction
          Shock Towers: Carbon fiber 0.12" (3mm) thick
          Steering: Ball bearing supported, mono-bellcrank with integrated
            adjustable servo saver, more Ackerman options for improved steering
            input rate, Ackerman describes the effect of the inner front wheel
            turning faster than the outer front wheel during turns
          Suspension: Front and rear sway bars with H.D.R.C (High Definition
            Roll Control) an aluminum center member that rolls on a bearing
            surface, roll stiffness is controlled and adjusted by the two wires
            mounted to the center member and linked to the suspension arms
          Bumper: Front foam
          Caster: Adjustable front & rear, caster/toe-in refers to the angle of
            the suspension when viewed from the side of the car in relation to
            the chassis, new caster block inserts for easier and quicker tuning
          Camber: Adjustable, camber refers to the angle of the tops of the
            tires from vertical when viewed from front or behind vehicle
          Battery Strap: Woven carbon fiber

INCLUDES: TC6 Factory Team Touring Car Kit, 40wt silicone shock oil, diff lube,
            decals and instruction manual

REQUIRES: Radio: 2-channel with high speed steering servo
          Motor: Brushless type recommended
          ESC: To match selected motor
          Pinion Gear: 48 pitch, number of teeth to be determined by motor and
            track conditions
          Body: 1/10 scale touring
          Tires and Wheels: 1/10 scale touring type
          Battery: 7.4V LiPo or 6.0V LiFe
          Battery Charger: Compatible with selected battery
          Building and track equipment

SPECS:    Length: 15"   (381mm)
          Width:   7.5" (190mm)
          Weight: 3.03lbs (1375g)
          Wheelbase: 10.04" (255mm)
          Internal Gear Ratio: 2.0:1

COMMENTS: For Replacement Ball Bearings use:
            Qty.  Size      Location                  Qty.   Bearing Set
             2    5x8mm   Fr Slipper Spool             1      DTXC1523
             2   10x15mm  Fr Slipper Spool             1      DTXC1595
             2    5x8mm   Rear Diff                    1      DTXC1523
             2   10x15mm  Rear Diff                    1      DTXC1595
             1  4x8mm flanged Spur Gear Shaft          2      DTXC1517
             4    6x10mm  Steering Blocks              2      DTXC1561
             4    6x10mm  Rear Hubs                    2      DTXC1561
             2    4x7mm Steering Bellcrank             1      DTXC1507

                                                                   jxs 12/13/11
                                                                         ir/jxs