This is the S9350 Digital Servo w/Two Ball Bearings for
         Car and Boat Use and Comes with "J" Connector Pre-Installed.
     Metal case acts as a Heat Sink to reduce Heat and is designed to be
                          Water and Dust Resistant.

FEATURES: Comes with Heavy Duty wiring that can handle Higher Current Loads
          New Metal casing which helps to dissipate heat
          Coreless Motor
          Dual Ball Bearing Output Shaft
          Metal Gears
          High Torque
          Dust and Water Resistant
          Great for 1/8 Cars or Boats Where Higher Torque and Speed are Needed
          One year warranty

INCLUDES: One Digital High Torque Servo w/Small Round Horn
          Four Rectangular Grommets
          Four Brass Bushings
          Four Mounting Screws
          One Large Round Horn
          One Six Arm Horn
          One Four Arm Horn

SPECS:    Speed:  .15 sec/60° @ 4.8V
                  .12 sec/60° @ 6V
          Torque: 111 oz-in (8.0 kg/cm) @ 4.8V
                  139 oz-in (10.0 kg/cm) @ 6V
          Dimensions: 1.6 x 0.8x 1.4" (40 x 20 x 37mm)
          Weight: 2.2oz (61g)

COMMENTS: S9350 Digital Servo Precautions,
          -It is best to avoid long leads and Y-harnesses especially with
           standard grade wires. If problems are encountered, consider using
           heavy duty wire such as Futaba's Heavy Duty Series or Hobbico's
           Pro Series, minimizing lead lengths, and/or removing Y-harnesses.
           -Current Drain:  Futaba S9350 Servo is Specially Designed for High-
            Torque and High-Speed, Therefore Very High Current Drain Is Normal
            At Startup. For Ultimate Performance When Using This Servo Please
            Review The Following Points.
            (1) When Using Systems With the Battery Fail Safe Function it Has
              a Higher Cut-Off Voltage Setting Which Will Cause Shorter
              Operation Time.
            (2) When Installing the Servo Please Check Pushrod Linkage To Make
              Sure There Is No Binding in Order To Prevent Excessive Power
              Consumption and Decrease the Life of the Motor and Battery.
         This digital servo cannot be used with the following * AM *
               transmitters as the servo neutral signal is: 1310us).
        CONQUEST AM, FG Series (T4FG, T5FGK,T6FG, T6FGK, T7FGK), New Terratop,
              T3EGX, T3PGE, T2NL, T2LGX, T2FR, T2PK series.

      ****   Otherwise they will work fine with current AM systems  *****

                                                              updt jxs 10/31/03