This is the glow powered, radio controlled, 1/8 scale
                      Mugen MBX6R Off Road Buggy Kit.

FEATURES: Chassis: Long version, A7075 T6 aluminum 0.12" (3mm) thick
          Drive: Four wheel three differential shaft drive
          Shocks: Four oil filled aluminum body
          Shock Towers: 0.16" (4mm) thick carbon graphite
          Gearbox: Sealed, front and rear
          Differentials: Planetary geared
          Fuel Tank: 4oz (120cc) approximate
          Radio Tray: Graphite
          Transmission: Single-speed
          Ball Bearings: Full set
          Suspension: Pillow ball with aluminum rear lower arm mount
          Body: Clear untrimmed buggy type with black plastic wing
          Clutch: 3-shoe aluminum
          Clutch Bell: 13 tooth steel
          Spur Gear: 46 tooth
          Camber Tie Rods: Adjustable, Camber describes the angle at which the
            tires sit vertically
          Steering Tie Rods: Adjustable, Caster/Toe-in is the angle at which
            the tires point inward as viewed from above
          Steering: Bell-crank type, with carbon graphite steering brace and
            adjustable Ackerman. Ackerman describes the effect of the inside
            front wheel turning faster than the outside front wheel during
            turns

INCLUDES: Mugen MBX6R Off Road Buggy Kit with clear buggy body, black plastic
            rear wing, decal sheet, window mask sheet, air filter, illustrated
            instruction manual, silicone shock oil and diff oil

REQUIRES: Engine: .21 cu in rear exhaust
          Exhaust: Tuned pipe with manifold
          Radio: 2-channel with standard servo for throttle and high torque
            servo for steering
          Tires: 1/8 scale buggy with foam inserts
          Wheels: 1/8 scale buggy
          Starter Box: For 1/8 scale buggy use
          Building and track equipment

SPECS:      Vehicle
          Width: 18.9" (480mm) measured at wheels
          Wheelbase: 12.4 - 12.6" (315 - 320mm)
          Gear Ratio: 11.98:1
          Weight: 7.4lb (3,370g)
            Body-
          Length: 14.4" (365mm)
          Width:   6.9" (177mm)
          Height:  3.9" (101mm)

COMMENTS: For replacement Ball Bearings use:
            Qty.  Size      Location            Qty.  Bearing Set
             6   8x16mm    Fr/R/Center Diffs     3     DTXC1585
             4   8x16mm    Fr/R Gear Cases       2     DTXC1585
             2   8x16mm    Front Hubs            1     DTXC1585
             2   15x21mm   Front Hubs            1     ASCC6862
             2   8x16mm    Rear Hubs             1     DTXC1585
             2   15x21mm   Rear Hubs             1     ASCC6862
             2   5x10mm    Clutch Bell           1     DTXC1535

                                                                   jxs 12/19/11
                                                                         ir/jxs