EMS Opto-Isolated E-Switch JR/Hitec/Z

Tower Stock# LXCJD7  •  Manufacturer Stock# EMO1012
EMS Opto-Isolated E-Switch JR/Hitec/Z (large view)
Notes from our tech department:
This is the Opto-Isolated E-Switch with Hitec/JR/Z connector.
This is a Solid-State Replacement for a Servo and Switch combined.

FEATURES

Adjustable ON point, reversing switch and LED indicator.
Optically isolated for no radio noise problems.
Use as "Old Timer" ignition cut-off, Glo driver switch,
Smoke pump control, or an On-Board Starter.
High Current Switching Capability
Selectable Stick Direction of ON/OFF
Positive Switching Point with Hysteresis for No Switch Center
Load Power Automatically Turns off when Receiver Power is Turned
OFF.
Works with AM, FM, and PCM radios.

INCLUDES

One Opto-Isolated E-Switch with Hitec/JR/Z connector.
One 6-1/2" piece of solder.

REQUIREMENTS

Soldering wires with included instructions.

SPECIFICATIONS

Length: 1.47" (37.5mm)
Width: 1.56" (39.6mm)
Height: .75" (19.1mm)
Weight: .7 oz (20g)

ir/kh

Resources
‐ Mailing Address ‐
‐ Additional Contact Information ‐