||NOTES FROM OUR TECH DEPARTMENT
This is a Dual E-Switch for JR/HIT/Z Radios by EMS|
Control Two Functions with one Radio Channel.
Each Output is rated for 5 continuous amps and up to 30 volts.
Each Output can be configured for Momentary or Latching Mode.
One E-Switch Unit
One Length of Solder
One Instruction Sheet
Soldering of Wires to Unit
Wire Length: 11"
Negative of battery gets soldered to two center hole on the board.
Positive wires from function (Motor, etc.) get soldered to the
holes closest to the MOSFETs.
Momentary mode means function will be ON while the radio stick is
away from center. When stick returns to center function will turn
Latching means function will turn ON and remain so when stick is
moved from center. Function will turn OFF when stick is
moved again in the same direction.
Unit is basically an ON/OFF switch that is controlled by the radio
stick. It would be similar to having extra switches on the
Unit is NOT proportional.
If either output of the Dual E-Switch is used to control a motor,
install a diode (1N4001) between the motor and the terminals.
– If you need more information, use these EMS resources –|
22605E LA PALMA AVE. STE 516
YORBA LINDA, CA 92887
Tower Hobbies Has Been Serving Hobbyists Since 1971 • Call 800-637-6050 or 217-398-3636
We accept the following: