This is the 2.4GHz Radio Controlled, Brushless Electric Powered
TxR (Transmitter Ready) Sensei Foam Trainer Airplane from Flyzone.
This is the Tx-R (Transmitter Ready) version that includes servos,
an ESC and SLT receiver.
With the AnyLink SLT 2.4GHz Radio Adapter (TACJ2000) (separate purchase)
and the appropriate AnyLink cable
with compatible aircraft transmitter
4-channels or higher may be used to fly this airplane.
See http://www.tx-ready.com/anylink-chart.html
for full transmitter compatibility chart.
**Additional Technical Info Will Be Added When It Becomes Available.**
FEATURES: Construction: Aero-Cell foam with "drop door" in fuselage to deploy
a parachute or other creative payloads while in flight
Wings: Two piece
Aileron Control: Dual servo
Tail Section: Attaches with one screw and features self-aligning
stabilizer
Motor: Brushless 1350Kv (FLZA6174)
Electronic Speed Control: 30A brushless compatible
Receiver: Tactic 2.4GHz SLT receiver
Servos: Five micro
Battery: 2100mAh 11.1V LiPo
Battery Charger: GPMM3319, LiPo compatible with balancing capability
AC/DC adapter and 12V cigarette lighter plug
Landing Gear: Main, prebent aluminum 0.098" (2.5mm) thick
Wheels: Three foam 2.5" (63.5mm)
Propeller: 10x5 plastic
Spinner: 1.75" (45mm) diameter black plastic
Warranty: Flyzone guarantees this kit to be free from defects in both
material and workmanship at the date of purchase. This warranty
does not cover any component parts damaged by use or modification.
INCLUDES: Sensei Foam Trainer Airplane with Motor ESC, five micro Servos, Prop,
Spinner, Landing Gear, Receiver, Wheels, Instruction Manual, Battery
and Charger
REQUIRES: Tactic AnyLink SLT 2.4GHz Radio Adapter (TACJ2000) to adapt aircraft
transmitter (the Futaba Square, TACM0001 and JR, Spektrum, TACM0002
are included with the AnyLink adapter)
*Tactic 2.4GHz 4 or 6 channel transmitters do not require the
AnyLink adapter
Pliers and phillips screwdriver
SPECS: Wingspan: 58" (1475mm)
Wing Area: 566 sq in (36.5 sq dm)
RTF Weight: 3.2lbs (1450g)
Length: 48" (1220mm)
Airfoil: Flat bottom
Configuration: High wing
Center of Gravity: Draw a mark 1/4" (7mm) back and 1/4" (7mm) forward
from the front of the aileron servo cover. The plane should
balance between these two marks.
Control Throws:
Elevator, Up/Down: 1/2" (15mm)
Rudder, Right/Left: 5/8" (16mm)
Ailerons, Up/Down: 1/2" (15mm)
jxs 01/16/12
ir/jxs
|