O.S. 46LA ABN w/Muffler

Tower Stock# LXGGV7  •  Manufacturer Stock# 13393
O.S. 46LA ABN w/Muffler (large view)
Notes from our tech department:
This is the .46LA engine from O.S. Max designed for sport airplane use.
This is a non-ringed engine with a Two-Year Warranty.
This engine has a natural finish w/"O.S." & "46LA" on the side.

FEATURES

1-piece crankcase
Crankshaft is set in one long bronze Oilite bushing (no bearings)
Schnuerle porting (AKA Schnuerle scavenging)
Side exhaust
Nylon backplate with remote needle valve
40D carburetor
Aluminum piston with Nickel-plated brass cylinder liner.

INCLUDES

One expansion-style muffler #E-3030
One instruction manual and sticker sheet
One assembled engine with glow plug
Two 3x30mm phillips head screws to bolt muffler to engine

SPECIFICATIONS

Construction: Aluminum 1-piece crankcase, piston, cylinder head
Bore: 23.0mm (0.906")
Stroke: 18.4mm (.724")
Horsepower: 1.2 PS, 1.18 HP at 15,000 RPM
Distance from remote needle to end of crankshaft: 4.5" (114mm)
Distance from center of engine to drive hub: 2.0" (51.2mm)
Distance from center of engine to end of crankshaft: 3.0" (76.3mm)
Height from crankcase bottom to top of cylinder head: 3.3" (84.7mm)
Height/crankshaft center to top of cylinder head: 2.7" (69mm)
Width including mounting ears: 1.9" (48mm)
Width not including mounting ears: 1.2" (32mm)
Width between mounting holes same side: 0.69" (17.5mm)
Width between mounting holes opposite side: 1.6" (40.5mm)
Width between muffler mounting holes: 1.4" (36mm)
Width of exhaust opening: 1.1" (29mm)
Height of exhaust opening: 0.3" (7mm)
Diameter of muffler body: 1.3" (33.5mm)
Angle of muffler in relation to engine: 4
Weight: 272g (9.6oz without muffler)
Crankshaft Thread Size: 1/4-28
Recommended Props: Break In: 11x6
Trainer and Sport Models: 11x6, 11x7
Scale Models: 12x5, 12x6
Practical RPM Range: 2,000 - 16,000 RPM (This engine will not turn
this many RPM on the ground) RPM curve is when the engine unloads.

REQUIREMENTS

Fuel with 5% - 15% Nitromethane and 18% (minimum) oil content
(Most of the 5%-15% fuels we carry meet these requirements)

COMMENTS

The factory setting of the needle valves are as follows:
High speed needle: Turn all the way in and back out 2 turns.
Air Bleed screw: Turn all the way in and back out 2 turns.
The coverplate for the FX Series will NOT work on this engine.

jxs 04/14/04
ir/jxs

Resources
Easy RC: Engines
‐ Mailing Address ‐
‐ Additional Contact Information ‐