Top Flite MonoKote Flat Sky Blue 6'

Tower Stock# LXHV70  •  Manufacturer Stock# TOPQ0506
Top Flite MonoKote Flat Sky Blue 6' (large view)
Quantity Discounts Available
Save $1.62
3 for $43.35
Notes from our tech department:
MonoKote is a Patented, Flexible High-Gloss Polyester Film that is Inexpensive,
Easy, Clean, and When Compared to "old fashioned" Coverings, Quick To Use.

For great covering ideas and to insure a professional finish, order
the MonoKote Covering Instructional DVD, TOPZ0105.


Super Strong with a Tensile Strength of 25,000 psi (pounds/sq in)
Lightweight at Only 0.2 oz/sq ft
Dry Adhesive Activates When Heat is Applied
Shrinks to a Drum-Tight Finish As It Cools
Fuelproof and Waterproof
Stronger and Lighter Than Traditional Silk and Dope Coverings
May be Cleaned with Glass Cleaner, "409" or MonoKote Cleaner/Polish


One (6' x 26") Roll of Flat Sky Blue Covering w/Instruction Sheet


Sealing Iron (TOPR2100), Heat Gun (TOPR2000), Iron Sock (TOPR2175)


Paints, Trim Sheets, EconoKote and Different Lots of MonoKote May
Vary Slightly In Color Between Production Runs of These Products.
If Using Three or More Rolls of the Same Color, it is Suggested to
Use a 25' Roll To Ensure the Same Dye Lot for the Entire
Model Being Covered.
LustreKote Primer Must Be Used With LustreKote Paint to Bring Out Its
True Color.
MonoKote Trim Sheet (Gloss): TOPQ4122
MonoKote (Gloss): TOPQ0206
MonoKote is a High Temperature Covering, NOT For Use Directly On Foam
EconoKote IS For Use Directly On Foam, Use the Following:
EconoKote Covering: TOPQ2601 TOPQ2612
(EconoKote may be used on top of, but not under MonoKote.)
* Temperature Ranges: Flat MonoKote Uses a Higher Temperature to Apply.
Attaching to Wood: 240 - 275F (activating the glue)
Partial Shrinkage: 230 - 270F
Maximum Shrinkage: 270 - 350F
TECH NOTE: The characteristics of the flat MonoKote differ slightly from
standard MonoKote covering:
Flat MonoKote requires higher temperatures to apply than standard
MonoKote because of the flat finish. In addition to the higher temp.
settings, this covering may require the iron to be in contact with
the covering and wood slightly longer than the standard finish.
If this covering is applied too loosely, it may be difficult to get
a tight shrink with this product. Also, when applied loosely, it
could become impossible to remove any wrinkles that may appear.

updated 4/30/03 ldt

See Tower Catalog page 69.
‐ Manufacturer's Web Page ‐
‐ Mailing Address ‐
‐ Additional Contact Information ‐