This is the complete 11H Slide Carb used on the following engines:
                        .12TZ(P)-T 3 PORT TURBO

FEATURES: Genuine O.S. replacement parts
          Slide carb design

INCLUDES: One complete 11H carb w/pre-installed Thermo Insulator OSMG6247
           and 5.5mm Black Carb Reducer OSMG2476
          One rubber carb gasket OSMG6220

REQUIRES: Installing on engine

SPECS:    Length:   0.87" (22mm) approx. including needle and idle stop screw
          Width:    1.7"  (44mm) approx. including needle and throttle arm
          Height:   1.71" (43.6mm) approx. including needle
          Diameter: 0.63" (16.1mm) OD of intake (throat)
                    0.51" (12.9mm)ID of intake (top) not including Carb Reducer
                    0.51" (12.96mm) OD of neck including thermo insulator
                     (the part that inserts into the crankcase)
                    0.26" (6.64mm) ID of neck @ narrowest point (top)
                    0.35" (8.88mm) ID of neck @ widest point (bottom)

COMMENTS: Carb can be identified with an "11H" on the back side of carb body

Needle Settings:
           Needle Valve (aka High Speed Needle):1¾ open from closed position
            per page 18 of engine manual.

           Mixture Control Screw (aka Low Speed Needle):The head of the mixture
            control screw is flush with the carb body per page 25 of eng manual

           Metering Needle: Head of metering needle screw is flush with the
            ball link body per page 25 of engine manual.

           Throttle Stop Screw: This is set so the rotor is still 0.5mm open
            when closed per page 18 of engine manual.
                                                                     tjt 052605
                                                                         ir/jxs