This is the radio controlled, electric powered, almost ready to fly
                        Multiplex Twin Star II Airplane.
                        For Intermediate Modeler/Fliers.

FEATURES: Construction: Elapor foam
          Wings: Two-piece foam with GRP tubular wing joiner
          Radio Compartment: Easily accessible under wing
          Motors: Two Multiplex Permax 6 volt 400 size with connector board
            and cables
          Landing Gear: None, model is intended for hand launches and belly
            landings
          Aileron Control: Dual Servo
          Hardware: Control horns, rods and all mounting hardware included
          Motor Mount: Wing mounted plastic motor brackets

INCLUDES: Elapor foam fuselage and wing halves, pushrods, two 400 size motors
             with connector board and cables, two propellers and spinners
             hardware package, tail section, decals, photo-illustrated
            instructions

REQUIRES: Speed Control: Electronic
          Battery: 7 or 8-cell flat
          Charger: Timed or peak
          Radio: 4-Channel
          Servos: Four micro (2-ailerons, 1-elevator, 1-rudder)
          Two Servo Extensions 12" (305mm): For aileron servos
          Y-Harness: For aileron servos
          Building and Field Equipment: Medium CA glue, activator, tools

SPECS:    Wingspan: 56" (1420mm)
          Wing Area: 665 sq in (43 sq dm)
          Weight: 53 oz (1500g)
          Wing Loading: 11.5 oz/sq ft (35 g/sq dm)
          Length: 43" (1085mm)
          Airfoil: Semi-symmetrical, high wing
          Center of Gravity: 3.3" (85mm) from the wing's leading edge at the
            fuselage sides.
          Control Throws-
            Ailerons: Up +0.71" (+18mm) & Down -0.39" (-10mm)
            Elevator: Up +0.94" (+24mm) & Down -0.59" (-15mm)
            Rudder: Right & Left 0.79" (20mm) each side

COMMENTS: For Brushless Motor Upgrade Pack, order MPUG3210.

          This model is NOT made of styrofoam and it is not possible to glue
            the material using white or epoxy glue. Medium CA glue used with
            an activator is the only method of gluing recommended by the
            manufacturer.

                                                                    jxs 9/15/05
                                                                         ir/jxs