Multiplex AcroMaster Kit 43"

Tower Stock# LXNXV7  •  Manufacturer Stock# M214215
Multiplex AcroMaster Kit 43
Notes from our tech department:
This is a Radio Controlled, Electric Powered, Elapor Foam Construction
Multiplex Acro Master 3D Airplane Kit.
For Intermediate to Advanced Modeler/Flyers.


Molded, Elapor Foam fuselage parts, white in color
Wings: Molded, Elapor foam construction, white in color
Radio compartment: Elapor foam construction
Cowling: Elapor foam construction
Canopy: Elapor foam construction
Landing gear: Pre-bent .10" (2.6mm) diameter wire
Aileron Control: Dual Servo
Wheel pants: Elapor foam construction, white in color
Spinner cone: Elapor foam construction, white in color
Hardware: .070" (1.75mm) diameter pushrods, plastic hinges, and other
miscellaneous hardware
Designed by Aerobatic Champion Martin Mueller
Motor Mount: White plastic construction
Wheels: Elapor foam construction with metal axle sleeve


Elapor foam airplane parts, pre-bent wire landing gear, 2" (51mm)
diameter wheels, fiberglass wing spar, hardware package, elapor
wheel pants and spinner cone, decals and illustrated instructions.


Motor and ESC : Multiplex Power Kit (MPUG3215), Includes Himax
HC3516-1130 Brushless Motor and Multiplex MULTIcont BL-55 ESC
Battery - 3 cell LiPo
Charger - LiPo compatible
Radio: 4-channel radio with micro receiver
Servos: 2 16oz/in torque minimum for the ailerons
2 35oz/in torque minimum for rudder and elevator
Servo Extension 12": 2 required for aileron servos - HCAM2100
Y-Harness: 1 required for aileron servos - HCAM2500


Wingspan: 43" (1095mm)
Wing Area: 557.27 sq in (36.6 sq dm)
Weight: 32-36oz (907-1020g)
Wing Loading: 8.19 oz/sq ft (25 g/sq dm)
Length: 45.25" (1150mm)
Airfoil: Fully-Symmetrical, mid-wing placement
Center of Gravity: 4-3/4" (120mm) Back from the wing's leading edge
at the fuselage sides.
Control Throws- Low Rate High Rate
Ailerons: Up & Down 1-3/8" (35mm) 2-3/16" (60mm)
Elevator: Up & Down 1-3/8" (35mm) 2-3/4" (70mm)
Rudder: Right & Left 1-3/4" (45mm) 3-1/8" (80mm)


This model is NOT made of styrofoam and it is not possible to glue
the material using white or epoxy glue. Medium CA glue used with an
activator is the only method of gluing recommended by the

Upd OA 3/13/2008

Know Before You Fly
Easy RC: Airplanes
‐ Mailing Address ‐
‐ Additional Contact Information ‐